Wheel Chock Lock Recommendation for Tires that are 5 inches Apart

Question

Question:

MY WHEEL SPACING BETWEEN THE TIRES IS 5 INCHES. SHOULD I BUY THE 5 1/4 OR THE 10 INCH MODEL. THANKS

asked by: Gary K

1

Helpful Expert Reply:

You would want to go with the Ultra-Fab Chock and Lock Wheel Stabilizer for Tandem-Axle Trailers and RVs # UF21-001080 this will work on wheels that are spaced between 4-1/2 and 10 inches apart; so it should work well for you.

I attached a review video for this product for you to check out as well.

expert reply by: Jameson C

1

Answer 1

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

To activate the brakes on a trailer with your 2024 Toyota Grand Highlander you'll need a 7-way connector and brake controller. To switch over from your 4-pin connector you can install the #ETBC7L. This will plug into your 4-pole connector and…

view full answer...

Answer 4

Sorry for any confusion that may have arose, but what you want is the U-Bolt Kit for Mounting 8,000-lb, Round Trailer Axles #APUBR-35. These are designed for 3 inch diameter, 8,000 lb axles and are compatible with the Roadmaster Comfort Ride Leaf…

view full answer...

Answer 5

The Fan-Tastic Vent Roof Vent w/ 12V Fan part #FV802250 is capable of moving up to 920 cubic feet of air per minute (CFM) at its highest setting. It also has two other settings with reduced cubic feet per minute ratings. The vent will fit most…

view full answer...

Answer 6

Yes, you can use the Roadmaster Comfort Ride Leaf Spring Suspension Kit 8K part #RM-2460-2580 with 7,000 lb axles.

view full answer...

Answer 7

The B&W Companion 20k #BWRVK3300 and 25k #BWRVK3305 base and head are going to differ in their components and construction, which results in the 25k hitch being about 10-lbs total heavier than the 20k hitch; so the 25k hitch head and base is a…

view full answer...

Answer 8

To be completely honest the sway control feature of the B and W Continuum part #BW78FR isn't nearly as advanced as the rest of the system. The advertised sway control of this system is in the head of the system between where the ball and the…

view full answer...

Answer 9

The kit you need is the part #UF21-001091. This setup is designed for wheel spacings of up to 10-1/2 inches so it would work well on yours that is 6-1/2 inches. Check out the review video I attached for more info as well.

view full answer...