Ultra-Fab Products Wheel Chocks - Wheel Chock - UF21-001070 Review Video

The Ultra-Fab Chock and Lock Wheel Stabilizers, #UF21-001070, with a pad lock cannot be defeated by loosening the nut. The chock is designed to protect the nut from unthreading once the chocks are in place. Check out the video I made for you that…

It sounds like the axles are not quite aligned. To determine if that is the case you can measure from the center of the front wheel to the center of the rear wheel on one side then do the same on the other side. If they are off by more than 1/8 of an…

The kit you need is the part #UF21-001091. This setup is designed for wheel spacings of up to 10-1/2 inches so it would work well on yours that is 6-1/2 inches. Check out the review video I attached for more info as well.

This is a known issue with some of these Dometic toilets here within the last year or so. The bowl seal may have a very slight deformity and it allows water to leak out. This will be covered under warranty thru Dometic. If the unit has not been used…

A weigh distribution system is going to be a really good idea based on the weight and size of the camper you plan to tow. You have a heavier duty truck so typically sway won't be too bad but the WD system will do an excellent job preventing sway…

When a trailer is loaded properly it will have a tongue weight (TW) that is 10-15% of the total weight of the trailer. Since 1,800 lbs is exactly 15% of 12,000 lbs you haven't overloaded the TW on your trailer. The best percentage of TW for a…

Yes, the Replacement Toilet Bowl Seal Kit for Dometic Sealand and VacuFlush RV Toilets #DOM35FR is the correct seal for your Dometic Sealand 210 Traveler Lite RV Toilet.

On the back side of the Dometic toilet there will be a label with part numbers and model info listed that you can check out to determine what model you have. The Dometic seal part #DOM63FR that you referenced fits 301,300,321,320,311, and 310 series…

The Optronics LED RV Exterior Scene Light - Submersible part #UCL41CB is a surface mount light that installs using the two mounting holes in the flanges on either side of the light. The distance between the mounting holes is 7.87" and the…

I do recommend using two pairs of the Ultra-Fab Chock and Lock Wheel Stabilizers #UF21-001070 for your triple axle trailer. Doing so is going to give you the best amount of stability to limit the front-to-back rocking motion that will occur when you…

If you were to order Ultra-Fab wheel chock #UF21-001060, you would receive 1 wheel chock. For a pair you can use part #UF21-001070. Having 2 will provide extra protection but using 1 is usually enough depending on your intended application. These…

The 2 inch spacing you have between the front and rear tires is enough to use Ultra-Fab chock #UF21-001060. It will fit tire spacing of 1-1/2 to 5-1/4 inches. I have included a link to a video review for you. For a set of 2 use #UF21-001070. You can…