Ultra-Fab Super Grip Chock Wheel Stabilizers Review Video

Measuring on the ground to the inside point of contact of each tire is the correct way to determine which chock setup you need. Yours being 16 inches at the closest point would most likely fall within the 16 to 24 inch range of the #FA84-00-4840.

I spoke with our resident Harley guy about what he thought of the B&W Biker Bar Motorcycle Tie-Down System for Trailers #BWMC2301 if he were to use it with his bike. Since the bike frame is designed to support not only its own weight but also…

B&W makes their Biker Bar motorcycle transport systems, such as #BWMC2301, just for hogs but we do have other setups for cruiser and touring motorcycle transport that are general-purpose products. You can see all of these wheel shock products…

The Ultra-Fab Chock and Lock Wheel Stabilizers, #UF21-001070, with a pad lock cannot be defeated by loosening the nut. The chock is designed to protect the nut from unthreading once the chocks are in place. Check out the video I made for you that…

There should be 2 inches minimum between the tires on a dual axle trailer. This will allow the suspension components room to work properly but a little more room is ideal. For instance the Ultra-Fab Chock and Lock Wheel Stabilizers for Tandem-Axle…

The kit you need is the part #UF21-001091. This setup is designed for wheel spacings of up to 10-1/2 inches so it would work well on yours that is 6-1/2 inches. Check out the review video I attached for more info as well.

This is a known issue with some of these Dometic toilets here within the last year or so. The bowl seal may have a very slight deformity and it allows water to leak out. This will be covered under warranty thru Dometic. If the unit has not been used…

Yes, the Replacement Toilet Bowl Seal Kit for Dometic Sealand and VacuFlush RV Toilets #DOM35FR is the correct seal for your Dometic Sealand 210 Traveler Lite RV Toilet.

On the back side of the Dometic toilet there will be a label with part numbers and model info listed that you can check out to determine what model you have. The Dometic seal part #DOM63FR that you referenced fits 301,300,321,320,311, and 310 series…

The Optronics LED RV Exterior Scene Light - Submersible part #UCL41CB is a surface mount light that installs using the two mounting holes in the flanges on either side of the light. The distance between the mounting holes is 7.87" and the…

The remote you need for your Jenson JWM72A is in the Replacement Service Pack for Jensen RV Stereo Item #JEN55VR.

I attached a picture that shows the proper position of shackles and equalizers on trailer suspension. Sometimes the shackle will flip up but if you jack up the trailer by the axle that's got the shackle flipped you can usually get it to flip back…