Ultra-Fab Chock and Lock Wheel Stabilizers Review Video

There should be 2 inches minimum between the tires on a dual axle trailer. This will allow the suspension components room to work properly but a little more room is ideal. For instance the Ultra-Fab Chock and Lock Wheel Stabilizers for Tandem-Axle…

The kit you need is the part #UF21-001091. This setup is designed for wheel spacings of up to 10-1/2 inches so it would work well on yours that is 6-1/2 inches. Check out the review video I attached for more info as well.

Yes, the #100019-24 pigtail can be used to connect your dual-cylinder 100 lb propane setup to the regulator on your RV. Since this hose does not have a back-check to contain a gas leak, you will need the #204120-MBS fitting that includes a…

That is not a problem, you can use Power Watchdog Surge Protector with Bluetooth, #HU47FR for a 50 Amp service and an adapter such as the Mighty Cord RV Power Cord Adapter Plug for 50 Amp Female to 30 Amp Male, #A10-3050AVP when needed. You want to…

The Die-Cast Grate for Furrion Range Cooktop #CFSRE21SA002 that you referenced weighs 8 lbs. You also are in need of the Replacement Trivet Support Bumper for Furrion Chef Collection Gas Cooktop #CFGH4ZSASSTRIVETSPRT.

Measuring on the ground to the inside point of contact of each tire is the correct way to determine which chock setup you need. Yours being 16 inches at the closest point would most likely fall within the 16 to 24 inch range of the #FA84-00-4840.

I spoke with our resident Harley guy about what he thought of the B&W Biker Bar Motorcycle Tie-Down System for Trailers #BWMC2301 if he were to use it with his bike. Since the bike frame is designed to support not only its own weight but also the…

B&W makes their Biker Bar motorcycle transport systems, such as #BWMC2301, just for hogs but we do have other setups for cruiser and touring motorcycle transport that are general-purpose products. You can see all of these wheel shock products on…

The Ultra-Fab Chock and Lock Wheel Stabilizers, #UF21-001070, with a pad lock cannot be defeated by loosening the nut. The chock is designed to protect the nut from unthreading once the chocks are in place. Check out the video I made for you that…

A weigh distribution system is going to be a really good idea based on the weight and size of the camper you plan to tow. You have a heavier duty truck so typically sway won't be too bad but the WD system will do an excellent job preventing sway…

The Equal-I-Zer part #EQ64FR that you referenced can fit trailer frames that are up to 8 inches tall so it would work great on your trailer frame that is 8 inches tall.

When a trailer is loaded properly it will have a tongue weight (TW) that is 10-15% of the total weight of the trailer. Since 1,800 lbs is exactly 15% of 12,000 lbs you haven't overloaded the TW on your trailer. The best percentage of TW for a…