Parts Needed to Operate Dutton-Lainson Hand Winch # DL14993 With a Drill/Driver

Question

Question:

Can I use the replacement handle DL6454 and drill drive DL6456 with this model?

asked by: Jason H

0

Expert Reply:

Yes, the Removable Handle Kit # DL6454 will fit on the Dutton-Lainson Hand Winch # DL14993. This will then allow you to use the Drill Drive Socket Adapter # DL6456 to operate your winch with your 1/2" drill/driver.

expert reply by: Bud M

0

Answer 1

The Dutton-Lainson Freewheeling Brake Winch #DL14993 is a light duty hand winch with a 1,200 lbs lift capacity. This winch has a self-locking brake that will provide additional safety and control while lifting. The Dutton-Lainson winch also includes…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

For your 2021 Chevrolet Blazer you're going to need to start with a base plate kit. Since there aren't any Blue Ox base plates I'd recommend going with the Roadmaster Direct-Connect Base Plate Kit #RM-523204-5. These are just as good as…

view full answer...

Answer 4

The brake controller port on a 2021 Ford F-150 (if equipped) will be located behind the coin tray in the center console. This will be accessed by removing the panel under the steering wheel. I have attached a video which shows this below. For a brake…

view full answer...

Answer 5

Yes, we do. To add a hitch to your 2024 Toyota Grand Highlander, I recommend the Curt Trailer Hitch item #C26VV. This hitch is custom fit and bolts to your Toyota with included hardware. This is a class III hitch with a 2" receiver. It has a…

view full answer...

Answer 6

To secure a cable on the Dutton-Lainson Worm Gear Winch - 1,500 lbs, #DL11011, you will use a series of loops around the reel and gear. You will not need to use a cable fastener or cable keeper to do this. I have attached a diagram that shows how the…

view full answer...

Answer 7

In cases where the weight of the load on the winch is too low to properly engage the winch brake you can use a worm gear winch instead. This type of winch uses a screw mechanism to operate the load. The weight of the load cannot cause the winch to…

view full answer...

Answer 8

For the ratcheting style winches like the part #DL16003 that you referenced there aren't any options that allow for a controlled feed out. For a winch that has a brake that works in both directions the Dutton Lainson part #DL14934 would be a…

view full answer...

Answer 9

Yes, the Dutton Lainson winch part #DL14934 is a brake winch like what would work great for raising and lower a Ham radio tower. This is the style that most people use so it would be a great option. For a cable you would want the part #DL24045.

view full answer...

Answer 10

If you're going to use a winch to raise and lower your popup you will want a winch that power loads both in and out. With a winch that will only power load in you will only be able to raise the popup and not lower with the winch. We have the…

view full answer...