Availability Of a Ball Mount With Friction Sway Control Tab Rated For 10,000LBS

Question

Question:

Item # D320 is this available in 10k also my boat is about 8500 lbs

asked by: David V

0

Expert Reply:

You do have a couple options but the Curt Ball Mount w/ Sway Control Tab # D320 is not available in a 10K weight capacity. You can use the similar Curt Ball Mount # C45310 rated for 10,000lbs and weld on a Sway Control Tab # C45822. We do also have the Bolt On Bracket # RP26003 but his has a 1" hole versus the 1-1/4" hole on the ball mount. So you will either need to drill the hole larger or use a 2-5/16" Ball # C40007 and Reducer Bushing # F-2. Then you will be able to mount the Friction Sway Bar # 17200

expert reply by: Bud M

0

Answer 1

I do have a recommendation as unfortunately the Friction Sway Bar #17200 is not surge brake compatible. Using a hitch like the Equal-i-zer Weight Distribution System #EQ37100ET integrates sway control into the weight distribution. Best of all it…

view full answer...

Answer 2

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

Unfortunately, the Reese #RP26003 wouldn't be compatible with the ball platform of the Gen-Y #325-GH-12001. However, Curt tells me that the ball platform of the #C45949 Curt Rebellion is about 2-5/8 inches in width, which is the largest width…

view full answer...

Answer 7

If you wanted to order the Curt Shock Absorbing Towing Starter Kit pat #C57DR without the brake controller you'd just need to order the individual components of the kit without the controller. So what you'd want would be the Rocker Ball…

view full answer...

Answer 8

Though I can confirm that InTech does use Dexter torsion axles, I was unable to find exactly which one and what angle is used on your 2020 Sol Dawn. So with that being said, what you will need to do is contact InTech with your VIN and they should be…

view full answer...

Answer 9

Hey Jaime, yes you can replace your 25-1/4 inch 3,500 lb axle leaf springs with a 5k rated axle spring like the part #e44SR. This will increase the suspension's weight capacity and might make the ride quality a little rougher but it would fit and…

view full answer...

Answer 10

Hey Kevin thanks for your question. There is not much downside to going with the 5,000 lb springs instead of the 3,500 lb. A higher rated spring may make the ride a bit more "chunky" at times, since the spring would not flex as easily.…

view full answer...

Answer 11

Installing a hitch like the Draw-Tite #76143 will NOT void the warranty of your 2017 Tesla Model X. The Magnuson–Moss Warranty Act protects you and allows aftermarket parts to be installed without warranty issues unless the install or part caused a…

view full answer...

Answer 12

I would be happy to help you. We hear this complaint quite often about dealerships not wanting to install after market wiring for random reasons because they want you to purchase theirs usually. The Curt Shock Absorbing Towing Kit w/ Sway Control and…

view full answer...

Availability Of a Ball Mount With Friction Sway Control Tab Rated For 10,000LBS

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching