Does Curt Hitch for 2022 Hyundai Santa Fe Allow Full Size Spare to Fit

Question

Question:

Fit with full sized spare on 2022 Hyundai Santa Fe? Can the tire still be raised and lowered if needed, or will the hitch interfere? Thanks for the help. Yall rock.

asked by: Jack S

0

Expert Reply:

Yes, the Curt hitch part # C34ER that fits your 2022 Hyundai Santa Fe does allow a full size spare to fit with it installed. You will end up needing to lower the spare to install the hitch though.

expert reply by: Jameson C

0

Answer 1

We definitely have what you need! For your 2021 Kia Sorento with a standard 235/60-R18 tire, I recommend using the Curt Hitch - 2" #C34ER. Not only does this hitch provide you with the highest weight capacity we offer for your vehicle, it also…

view full answer...

Answer 2

There is indeed one trailer hitch receiver that is a fit for your 2022 Hyundai Santa Fe that has a completely concealed crosstube, which is from Curt: - Curt Trailer Hitch Receiver #C34ER I have added a photo below showing this hitch installed so you…

view full answer...

Answer 3

The Curt Echo Mobile Trailer Brake Controller #C51180 does share the 12V power with the trailer (page one of the linked install instructions) so your battery will still receive a charge but it will be reduced since the Echo will be diverting some of…

view full answer...

Answer 4

The Curt Trailer Hitch Receiver part #C34ER which is a fit for a 2021 Kia Sorento will allow the spare tire to be raised and lowered as needed without removing the hitch.

view full answer...

Answer 5

Most of the photos I've seen of the Keystone Passport show a rear-mounted spare tire that would interfere with mounting a bike rack in a rear mounted hitch. If you don't have a spare tire, the Curt #13703 would work for you. A rack mounted on…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

Yes, we do. To add a hitch to your 2024 Toyota Grand Highlander, I recommend the Curt Trailer Hitch item #C26VV. This hitch is custom fit and bolts to your Toyota with included hardware. This is a class III hitch with a 2" receiver. It has a…

view full answer...

Answer 9

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...

Answer 10

There is a trailer hitch receiver as well as a 4-way wiring harness that fit your 2022 Jeep Grand Cherokee WL; that said, we don't have any way to reference a VIN so you'll need to confirm if you do have the WL, which is the new model of…

view full answer...

Answer 11

There is only one difference between the Curt Trailer Hitch Receiver #C13176 and etrailer Trailer Hitch Receiver #e98909 that fit your 2020 Chevrolet Colorado, which is the finish. The Curt trailer hitch has a glossy black finish while the etrailer…

view full answer...

Answer 12

To replace your NOK AD2527E seal you can use #168233. It has an inner diameter of 1.688 inches and an outer diameter of 2.332 inches. Based on what I could find on the NOK AD2527E the inner diameter is the same and the outer diameter is 2.328 inches.…

view full answer...