Can the Curt Stabilizer Strap Be Attached Lower to Accommodate Glass Hatchbacks

Question

Question:

I bought the curt 1.25 bike hitch and it came with this part. The problem is Im worried about attaching this to my hatchback since it is glass. Does Curt make a support strap for hatchbacks?

asked by: John

0

Expert Reply:

You might have to get a little creative with how you install the Curt Stabilizer Strap # 18050 since you have a glass hatchback. We have seen people attach the hook end to the bottom lip of the hatch back since this is metal. This would require the strap attach to the bike rack lower than usual as well.

expert reply by: Jameson C

0

Answer 1

It sounds like you are describing Curt stabilization strap #18050. It is used to take some of the stress off of the trailer hitch. I have linked a video showing how this strap works and it sounds like what you are describing.

view full answer...

Answer 2

Ok, we can get either your 2010 Toyota Prius or 2018 Kia Soul set up to carry electric bikes, but you are correct that there isn't an option for a Class II, 1-1/4 inch hitch for either vehicle. That said, you can still carry your electric bikes,…

view full answer...

Answer 3

The only way you'd be able to carry an 80 lb e-bike with a 2010 Toyota Prius would be to first install a 2 inch hitch on the vehicle like with the EcoHitch part #306-X7178 so that you could then carry an e-bike rack with a higher weight capacity…

view full answer...

Answer 4

Good news, I went out and grabbed the Anti-Rattle Hitch Lock for SportRack Bike Racks and Cargo Carriers #SR0901 and one of the Curt Premium 4 Bike Racks part #C18064 that you also referenced to test the two and found that the hitch lock fits the…

view full answer...

Answer 5

You have a couple options to use the Curt Stabilizing Strap, part #18050 with a spoiler. One option is to use two straps and hook to either side of the rear hatch, circumventing the need to attach to the spoiler at all. You would need to put a lot of…

view full answer...

Answer 6

The up and down play that you are experiencing is due to the tolerances that different manufacturers must allow to be sure that all accessories will work in conjunction with each other. In this case the hitch and bike rack are compatible but there is…

view full answer...

Answer 7

Per Curt warranty requirements, all non-trailer loads, which will include a platform bike rack, must be supported by stabilizing straps. You can use the Curt Trailer Hitch Support Strap, part #18050. We offer a wide variety of platform bike racks…

view full answer...

Answer 8

I recommend starting by just taking a look and ensuring the anti-rattle device of your bike rack is functioning properly and in good working order, and if it is, we do have a great solution. Since your Thule Apex Swing XT 4 Bike Rack #TH9027XT is…

view full answer...

Answer 9

Since there are no specific instructions on how to install the Support Strap #18050 you can get a little creative. If you are afraid of damaging the spoiler on your 2017 Volkswagen Golf then I recommend installing the clip part of the strap in the…

view full answer...

Answer 10

I checked with Yakima and they state that when installing the Hangout 2 part #Y02637 on a 2016 Jeep Cherokee the lower hooks must be changed and installed in anchor mode so that is the way you should install the rack. I attached a picture that shows…

view full answer...

Answer 11

Thanks so much for your purchase, and I can tell you that the Curt Cam Buckle Stabilizing Strap #18050 is not a requirement for use with the Curt Trailer Hitch Receiver #C13206. While Curt does recommend the use of the strap, it is not needed in…

view full answer...

Answer 12

The Curt Cam Buckle Stabilizing Strap #18050 is usually used on Class I or Class II hitches to help distribute the weight on them. Since your hitch #C13136 for your 2013 Ausi Q5 is a Class III hitch, then it does not need the stabilizing strap. If…

view full answer...