Does Torklift Hitch # TLF1002 Fit 4WD and 2WD Versions of 2011 Ford F-250

Question

Question:

My truck is a 2011 F250 Super Duty 2WD Diesel. Is there any difference in frame mounts between the 2 and 4 WD trucks, I assume the TLF1002 mount is the correct one for my truck.

asked by: Richard B

0

Expert Reply:

The Torklift hitch part # TLF1002 fits both 2WD and 4WD versions of the 2011 Ford F-250 that you have so either way it does fit.

expert reply by: Jameson C

0

Answer 1

The Torklift SuperHitch part #TLF1002 you referenced is designed to fit truck frame widths of 37-3/4 inches wide from outside to outside. The distance from left to right for the bolt holes is 34.31 inches. The trucks it fits are: 2015 - 2016 Ford…

view full answer...

Answer 2

Hi Jeremy; yes, the Stay-IN-Play Duo Flat Tow Brake System #SM99251 will work on a 2018 Chevy Equinox, including with the diesel engine.

view full answer...

Answer 3

Hey Mark, What gauge wire did you use to run from the junction box to the brake assemblies? If you didn't use at least 10AWG wire #10-1-1 that could explain the heat build up and voltage drop. I don't recommend leaving the manual override…

view full answer...

Answer 4

Hey Mark, If your Terrain has a plug like the one pictured below then you should have the tow package and be able to use the Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector #C94FR. This harness has relays to plug into…

view full answer...

Answer 5

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 6

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

The current Torklift tie down part #TLD3101 that you have installed on your 1997 Dodge Ram 3500 only fits if you have the factory hitch. If you go with the SuperHitch part #TLD1100 you would need to change your rear tie down to the part #TLR3503.

view full answer...

Answer 9

Hey Robert, sorry it can be a bit confusing navigating all those facets for the camper tie downs, but I did go ahead and find those tie downs you were looking for. For the front, you'll want the TorkLift Camper Tie-Downs #TL87CR (TorkLift P/N…

view full answer...

Answer 10

Great question, Jeff! When the Rota-Flex first came out it renovated what a pin box could do and be, but at this point in time that technology is a little more dated and the Gen-Y Hitch Shock Absorbing 5th Wheel Pin Box #325-GH-8040 is the "new…

view full answer...

Answer 11

The 1-5/16" Hellwig Adjustable Big Wig Rear Anti-Sway Bars are designed for 2WD #HE97MR or 4WD #HE94FR versions of your 2021 Ford F-250. These are both designed for trucks which have a stock ride height. Hellwig does offer their 2" Lift…

view full answer...

Does Torklift Hitch # TLF1002 Fit 4WD and 2WD Versions of 2011 Ford F-250

Product Page this Question was Asked From

Continue Researching