What Width is Replacement Hasp for Polar Cam-Action Latch # PLR158-102-A Designed to Fit

Question

Question:

i have a featherlite trailer my closing arms are 1.25 will this hasp latch work with my arms

asked by: Peter W

0

Expert Reply:

Yes the part # PLR158-102-A was designed to be used with handles that are 1-1/4 inches wide like you mentioned having.

expert reply by: Jameson C

0

Answer 1

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 2

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and…

view full answer...

Answer 3

The Galeo Pro GPS Tracking Device #GA94FR has a motion sensor built in so it will "ping" the location whenever it moves or senses vibration. You can also press the "Locate" button within the app to get a ping on…

view full answer...

Answer 4

From what I could find out about your current circuit board, the Atwood Replacement Control Panel #AT91367 will be a direct replacement.

view full answer...

Answer 5

We sure can! The Transcom #TCM 21344 TB cross references to the 10-10 seal we offer, part #RG06-090. The seal has a 2.125 inch ID and a 3.376 OD. It's compatible with a 25580 inner bearing.

view full answer...

Answer 6

We offer two Paneloc lock hasps that are 1-1/2-inches wide, parts #H145-203E and #H135-203E, both of which are shown on the linked page. We also offer cam door latches like 2-inch #PLR158-102-A and #PLR158-102-SS, as well as 1-inch hasps like…

view full answer...

Answer 7

From what I have found, the ALKO hub and drum assembly you have is for 7,000 lb axles. I believe the Dexter Trailer Hub and Drum Assembly for 5,200-lb to 7,000-lb Axles - 12" - 8 on 6-1/2 #8-219-4UC3 will work as a replacement. This has the same…

view full answer...

Answer 8

The Coachmen Chaparral with Turn-Tec Engineering should allow for a fixed fifth wheel hitch to be used while making full turns so a sliding fifth wheel hitch or rotating pin box is not needed. The sliding fifth wheel hitches are very heavy so it…

view full answer...

Answer 9

I can't confirm that #048-022-00 replaces the AL-KO adjuster number. Its designed to replace the adjustment screw on 10" and 12" Dexter Nev-R-Adjusting brakes. However if you are needing to replace the adjusters on your 12" AL-KO…

view full answer...