Could MaxxAir RV Cover # MA00-933069 Fit 2017 T@B 320S

Question

Question:

Does Item # MA00-933069 Maxxaiar Vent Cover work for 2017 T@B 320S ?

asked by: George H

0

Expert Reply:

Since the MaxxAir Standard RV and Trailer Roof Vent Cover # MA00-933069 can fit basically all standard RV covers it would fit and work great on your 2017 T and B 320S.

expert reply by: Jameson C

0

Answer 1

Yes, the MaxxAir II RV and Trailer Roof Vent Cover w/ EZClip In White #MA76JR, Black #MA86JR and Smoke #MA26JR will attach to the mounting tabs already found on MaxxFan and MaxxFan Plus roof vents. You may not be able to fully open the roof vent with…

view full answer...

Answer 2

The Reese Goose Box 5th-Wheel-to-Gooseneck Air Ride Coupler Adapter part #RP85FR is compatible with the gooseneck tripod stabilizer Ultra-Fab Gooseneck Trailer Tripod Stabilizer part #UF19-950450 which I recommend. The Ultra-fab tripod has a height…

view full answer...

Answer 3

Most roof vents follow the standard size opening. That size is 14-1/4 inches by 14x1/4 inches but it is most commonly referred to as 14 x14. Many different vents on the inside and outside flanges can have different measurements to gain a certain look…

view full answer...

Answer 4

The Dometic RV Water Heater - Gas - Automatic Pilot - 12 Volt - 8,800 Btu - 6 Gal Tank Item AT96121 is the direct replacement for the GC6AA-10E. Unfortunately it is out of stock with no expected restock date. Instead I recommend the Furrion RV…

view full answer...

Answer 5

Actually the type of roof vent cover you need to attach to the vent cover brackets of your Maxxair 4951KS like part #MA00-04500K is the part #MA00-955003 which uses those brackets with the included cotter pins of the cover.

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

Hey Frankie, The bracket for the Timbren Suspension Enhancement System #TFR250SDJ has a locknut in it that makes it feel like the bolt (part #4) is fully tightened when it's not. Their techs have stated that you just have to push past this point…

view full answer...

Answer 8

For a 29.5" doorway with a 36.5" stair height I recommend the MORryde StepAbove RV Steps for 27-3/4" to 30-1/4" Wide Doorways - 4 Steps item #MR28RR. These steps are for entryways with a doorway width (from inside flange to inside…

view full answer...

Answer 9

We have a large selection of RV steps available that may work great on your 2016 Forest River Prime Time Crusader. When trying to locate a step assembly that will fit your trailer, you will first want to determine the mounting base measurements of…

view full answer...

Answer 10

The Timbren kit #TFR250SDJ does not require a mounting plate above the axle as it is designed to contact the round the plate that is currently on the axle that is mounted below the spring pack. I would recommend sticking with this kit even though you…

view full answer...

Answer 11

Since the distance from your threshold to the ground is 38", and the narrowest part of your door is 28-1/4" side-to-side, the MORryde steps that are a fit for you are the MORryde #MR28RR steps featuring 8" deep steps. Optionally you…

view full answer...

Answer 12

The height of the Aeon hollow rubber springs on the Timbren Suspension Enhancement System - Rear Axle #TFR250SDJ is 4-1/2". The overall height for the Timbren system is 6-7/8". See the helpful diagram below which shows both measurements. I…

view full answer...

Could MaxxAir RV Cover # MA00-933069 Fit 2017 T@B 320S

Product Page this Question was Asked From

Continue Researching