Recommended Sidewind A-Frame Mounted Trailer Jack With Leg

Question

Question:

I am looking for a round A frame jack with a side wind handle and leg. Is there a jack like this that you handle? Or Can you put a TJA-5000S-B jack with a JF-1005H-Z extension? Thank you for your time

asked by: Joel K

0

Expert Reply:

The etrailer A-Frame Round Jack # TJA-5000S-B is a great sidewind jack. It is rated for 5,000lbs capacity and will extend to 24" below the mounting bracket.

The Drop Leg for etrailer and Ram Jacks - 13-1/4" Tall - 5-1/4" Diameter Footplate - Zinc # JF-1005H-Z will work with the etrailer.com jack # TJA-5000S-B. This can add up to another 8" of lift to your jack. There are 5 separate pin hole locations that are set on 2" centers to give you a range of positions.

You could also take a look at the Trailer Valet JXC Trailer Jack w/ Footplate and Drill Powered Option # TV94FR. This has a removable handle and will allow you to use a cordless drill when desired to raise and lower the jack on your trailer. It has a fully extended height of 23-1/2" below the mounting bracket and has a support capacity of 5,000lbs and a lift capacity of 3,000lbs.

expert reply by: Bud M

0

Answer 1

I do have an option for you but there isn't a drop leg available for the Trailer Valet JXC Trailer Jack part #TV54FR or part #TV94FR. If you're after faster operation or less work then you may want to take advantage of the drill…

view full answer...

Answer 2

The Trailer Valet JXC Trailer Jack w/ Footplate and Drill Powered Option, #TV94FR is a replacement. You will need to remove the Braber BE-130 Jack. The Trailer Valet, #TV94FR has an outer tube diameter of 2-1/4". My suggestion is to measure…

view full answer...

Answer 3

The highest capacity trailer tire we offer that fits a 14 inch trailer rim is the Load Range D part #TTWTRTM2157514D which has a capacity of 2,200-lb max load at 65 psi. With trailer tires you have to keep them inflated to their max psi at all…

view full answer...

Answer 4

Yes, you can replace your load range C tires with load range D tires without issue. It will only become any issue when you go down load ranges, not up. The tires will have the same overall diameter as long as they are the same size regardless of…

view full answer...

Answer 5

I'll start out by saying that the Goodyear Endurance tires that we carry are all radial tires, but we do not have any available in a 205/75R15. However, if you're looking for a bias ply tire with those measurements I recommend using…

view full answer...

Answer 6

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...