etrailer Round A-Frame Trailer Jack Review Video

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

The Round A-Frame Trailer Jack #TJA-5000S-B outer tube is 2-1/4" thick so the pilot hole in the frame would need to 2-1/4" or larger in diameter. The mounting holes are oblong and are 3/4" long x 7/16" wide with a center to center…

I can end this debate for you real fast! Trailer tires, which will have an ST in front of the size, should always be inflated to the maximum psi indicated on the tire. Trailer tires usually do not have a recommended and maximum psi indication so I am…

When installing marker lights we recommend using 18 gauge wire like #SWC97FR. This is stranded wire and is what we typically use when wiring marker lights like the #MCL32ABB for example. LED marker lights pull very low amperage so 18 gauge is likely…

The only difference between 7-Way Utility and 7-Way RV is the color of the wires. The pin outs are the exact same so either would work just fine with the other. If you check out the picture I attached you'll see that the functions are all the…

Yes the Demco A-Frame Trailer Coupler #DM14793-97 could be welded instead of bolting it to the trailer. Instead though I would recommend the #DM14793-52 which isn't primed so would be a bit easier to weld.

The Demco A-Frame Trailer Coupler part #DM14793-97 is designed for a standard a-frame trailer with a 50 degree angle. This is the most common type so there really shouldn't be any other issues that affect fit. That said, I have attached some…

You would choose a side wind or top wind jack based on several factors. Each has its advantages. If clearance is an issue for the radius of a top wind, then you would choose a side wind. The opposite is also true. It is my experience that a side…

Since you will be at a campground the best way for you to move an enclosed motorcycle trailer is a dolly and a great option is the Trailer Valet 5X Swivel Jack and Trailer Mover #STC-V211 because it is a combination jack and dolly that has rubber…

So there's an obstruction on your trailer frame that prevents you from installing the chain hanger brackets where they need to be, is that correct? We have the perfect solution for you. The Reese Bolt-On Chain Hangers, part #RP58305 should work…

All of the A-frame couplers we carry are for the standard 50 degree A-frames. What you could do, since your A-frame is a lower angle, is have some steel spacers welded on to get to 50 degrees and then use a weld-on coupler. I have linked the weld-on…

I would use a protractor, see photo, place the protractor on the edge of the inside of one side of the trailer frame and the other inside edge of the trailer frame should be parallel with the 50 degree line on the protractor. Another way to verify…