Do Both Upper Bolts of Lippert Tandem Axle Lift Kit part # LC407131 go Through Spacer

Question

Question:

Its hard to tell from the instructions. Do both of the upper mounting bolts go thru the spacer or just the lower bolt?

asked by: Scott R

0

Expert Reply:

Yes both of the upper bolts of the Lippert Tandem Axle Lift Kit part # RR23QX go through the spacer like you mentioned.

expert reply by: Jameson C

0

Answer 1

The Westlake would be by first choice like tire part #LHWL410. This is actually a Load Range G so the capacity is 4,400-lb max load at 110 psi .This Westlake tire has a speed rating of 81 mph and also has a great warranty as well. The Taskmaster…

view full answer...

Answer 2

The TireMinder i10 TPMS for RVs and Trailers w/ Signal Booster - 4 Tire Sensors #TM89FR is a great system that sets the temperature at 167 degrees Fahrenheit for the initial alarm to warn you to stop soon and let the tires cool as well as checking…

view full answer...

Answer 3

Yes, along with the vast majority of vehicles tires, special trailer tires like #TTWPRG235R16 are often made in China or elsewhere offshore. These tires are produced on the same type of manufacturing equipment used here by domestic manufacturers and…

view full answer...

Answer 4

Westlake tires and 99% of ST rated trailer tires are made overseas, but meet or exceed the DOT and FMVSS specifications. The Westlake brand is one of the most popular trailer tire brands out there and customers have been very happy with them. They…

view full answer...

Answer 5

The U-bolts of the U-Bolt Kit part #SP01-080 are Grade 5.

view full answer...

Answer 6

Trailer tires should always be filled to the max psi listed on the sidewall while cold. The heat would indeed cause the pressure to build but not to a point where an issue would occur. You are taking around 10 psi and that would not be the cause of a…

view full answer...

Answer 7

The Westlake ST235/85R16 Radial Trailer Tire #LHWL410 is definitely a high quality trailer tire. I don't know where you saw all of the reviews for the S637, but the Westlake is well reviewed with a 99% satisfaction rating here at etrailer. The…

view full answer...

Answer 8

I spoke with MORryde and they said that the MORryde X-Factor Crossmember for Standard Frame Hangers #MR33WR will work just fine with your frame hangers with gussets. You'll just need to use the circled items attached in the image below and…

view full answer...

Answer 9

Trailer tires can be balanced but you should note that normally they are not. What happens most of the times is that the person mounting the tire will line up with light spot of the tire with the heavy spot of the rim and it gets the setup about as…

view full answer...

Answer 10

There are a couple things that you will want to verify first, but more than likely you will be able to switch from your current 16" wheels to 17.5" wheels like the Aluminum Lynx Trailer Wheel #274-000006 you were looking at. The width of…

view full answer...

Answer 11

From what I have found, it looks like you have tandem 7,000 lb axles on your 2014 Prime Time Sanibel 3600. Assuming that is the case, we have two different replacement shocks available for two different systems. If you have the Lippert Bolt-On Shock…

view full answer...

Answer 12

If you are looking to add shocks then measure using the following procedure: Compress the shock all the way (A) then mark the inner leg where the outer leg stops. Then release compression and measure the stroke (how far the shock moves) (B). Then…

view full answer...