Cable For Fulton High-Performance 2-Speed Trailer Winch F142400

Question

Question:

Does the Fulton High-Performance 2-Speed Trailer Winch - Rope Only - Zinc - 2,000 lbs come with the cable?

asked by: Kayla K

0

Expert Reply:

We have the correct cable, but it does come separately from the Fulton High-Performance 2-Speed Trailer Winch # F142400.

The correct part you will need is the Fulton Galvanized Winch Cable with Hook # FWC3250100.

expert reply by: Kyle S

0

Answer 1

The Fulton Galvanized Winch Cable #FWC3250100 that you referenced would work great. It has more that enough capacity and it matches the dimensions you need as well.

view full answer...

Answer 2

The Fulton T2005 2-speed winch has been discontinued, and as such there is not a replacement drum for it. While I know it's not the answer you were looking to hear, the only option we have for you is to replace your winch, and the direct…

view full answer...

Answer 3

From what I found your 1991 Chaparral 1900 Bowrider weighs 2,200 lbs so it is likely the 3,250 lbs is the GVWR of the trailer. The best option for a winch that will have plenty of capacity is the following: - 2-Speed Boat Trailer Winch #315-W2500D…

view full answer...

Answer 4

The winch cable I recommend for a Shelby 5480A Boat Trailer Winch is the Fulton Galvanized Winch Cable with Hook part #FWC3250100 which measures 25' long and has the needed weight capacity. In regards to weight ratings, there are many factors…

view full answer...

Answer 5

Yes the bolt pattern of the Dutton-Lainson Hand Winch #DL15440 is close enough to the Shelby you mentioned that it would easily fit in place of it.

view full answer...

Answer 6

When our installers replace a trailer hub, there isn't a set torque spec used when tightening the spindle nut. The hub is placed on the spindle, making sure the inner and outer bearings are correctly seated. The spindle nut is then run down until…

view full answer...

Answer 7

We don't currently have any customer submitted photos for the Brophy Heavy Duty Cable Camper Jacks #CX74, but we do for the lower capacity #CJ74, which uses the same lift brackets. From the edge of the tube to the lift bracket is approximately…

view full answer...

Answer 8

Whereas the Fulton #F142400 will work with just wire rope, like the #FWC3250100, the Fulton #F142401 will work with wire rope and also a strap, like the #FWS20HD0200. With both of these having a capacity of 2,000 ponds and being high performance 2…

view full answer...

Answer 9

I do have a video for the Fulton #F142401 which is nearly identical to the #F142400 that you were looking at. The only difference is that the #F142401 can be used with a strap or wire rope, while the #F142400 can be used with rope only. Other than…

view full answer...

Answer 10

I took a look at what we have for your Fulton T2005, and it turns out that this winch has been discontinued and unfortunately there is not a replacement for it, however I do have another alternative. Instead, I recommend upgrading your older T2005…

view full answer...

Answer 11

The Brophy Heavy Duty Cable Camper Jacks #CX74 may be able to work for you depending on the configuration of your camper. They do not have the same design in terms of fitting into the corners of your '73 Ford camper; the Brophy #CX74 uses…

view full answer...

Answer 12

In order to replace your Carrier Air V RV Air Conditioner I highly recommend using the Advent Air Replacement RV Air Conditioner for Carrier Setup part #ACCAR150 for 13,500 Btu's or part #ACCAR135 for 15,000 Btu's. This unit will be the only…

view full answer...