What Does 2 Dots on Curt TriFlex Brake Controller Mean

Question

Question:

Only have 2 periods . . On con troller what does the mean . . On my triflex

asked by: Pat

0

Expert Reply:

The two dots like . . on the Curt TriFlex, part # C24VV, just means that the controller is in standby mode with a trailer connector.

If you have a trailer connected and aren't doing anything else with the controller this is normal.

expert reply by: Charles S

0

Answer 1

If you check out the attached instructions for the Curt TriFlex Trailer Brake Controller #C24VV you can see that the OL code you are getting means that there is an "Overloaded output circuit, trailer brake system fault". Whichever…

view full answer...

Answer 2

If the display on your Draw-Tite Activator Brake Controller, part #5504, shows the letters OL,or Overload Code, that is an indication that there is a short in the Blue wire circuit. The Blue wire supplies power from the controller back to the trailer…

view full answer...

Answer 3

It sounds like the problem is corrosion on the trailer 7-way brake output circuit which is causing the controller to only show an intermittent connection. Try cleaning off this pin on the 7-way with some fine grit sandpaper. Testing the brake…

view full answer...

Answer 4

Electric trailer brakes like the Dexter Nev-R-Adjust Electric Trailer Brake Kit #23-458-459 should only utilize two wires, the power and the ground. You do need to connect each of the wires to your brake assemblies, and each should have its own…

view full answer...

Answer 5

It is normal to have continuity between the brake(blue) wire and ground(white) wire. The electric trailer brake is an electromagnet when it has power it attracts to the steel inside the hub/drum. If you are having issues with your trailer brakes…

view full answer...

Answer 6

You are correct, you should only be getting output when the brake is applied, or the override switch is activated. It sounds like the controller might be bad, but to make sure, you should probably bench test it before tossing it. Use a circuit…

view full answer...

Answer 7

Without knowing what brake controller you have I will venture to guess that the OL code you are seeing is an over load code. The OL or overload error code indicates a short in the brake output circuit. Start by examining the trailer connector. Make…

view full answer...

Answer 8

The Adco SFS AquaShed Cover for Bumper Pull Trailer part #290-46004 would be an excellent option for a 7 x 14 V-Nose Enclosed Trailer. The Adco SFS AquaShed Cover for Bumper Pull Trailers is actually designed for horse trailers but it will work well…

view full answer...

Answer 9

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 10

Yes, the Replacement Cover #PE48UV will indeed fit the 2018 Ford F-150 extended cab with the 67" bed. This is made to be a replacement cover for the Pace Edwards JackRabbit Retractable Hard Tonneau Cover #311-JRFA05A28 which is specifically for…

view full answer...

Answer 11

The 2" receiver for the EcoHitch item #EH87SR sticks out right through the middle of the air dam. I have attached a picture below that will show you what this front hitch looks like once installed. The EcoHitch Hidden Front Mount Trailer Hitch…

view full answer...

Answer 12

I spoke with my B&W representative who confirms that to install their GNRK1121 #BW77FR Turnover Ball hitch on a 2021 Ford F-150, the center of the 4 inch hole for the gooseneck ball would be placed 42-5/8 inches forward of the rear edge of the…

view full answer...