What Does an Intermittent Flashing OL Code Mean for a Brake Controller
Question:
have a 2006 homested camper has roughly 10000 miles brake controller started flashing ol code adjusted brakes it seemed to help but still doing it looking for suggestions
asked by: Stephen T
Expert Reply:
Without knowing what brake controller you have I will venture to guess that the OL code you are seeing is an over load code.
The OL or overload error code indicates a short in the brake output circuit. Start by examining the trailer connector. Make sure that the pins on the vehicle side of the connection and the sockets on the trailer side are not damaged or corroded. If you can see green corrosion on the pins or the sockets, there is a possibility that the corrosion may have spread to the interior of the connector itself, causing a short. Trace the output circuit back from the connector to the trailer brake magnets. Check the brake output wire (usually a blue wire) for pinch points or worn or cracked insulation. If at any point in the circuit there is copper conductor showing, it can possibly short out on the trailer frame. You will also want to examine your brake magnets and their connections. Make sure that the ground connection for each magnet is securely attached to the trailer frame. Check that the brake magnets are not excessively worn. If you pull the brake drum off and can see the copper windings through the face of the magnet, it is time to replace them.
Product Page this Question was Asked From
Electric Trailer Brake Assembly - 10" - Left Hand - 3,500 lbs
- Accessories and Parts
- Trailer Brakes
- Electric Drum Brakes
- LH
- 3500 lbs
- Brake Assembly
- Manual Adjust
- 10 x 2-1/4 Inch Drum
- etrailer
more information >
Continue Researching
- Shop: MORryde X-Factor Crossmember Adapter Kit for Correct Track Hangers
- Shop: Brake Controller
- Shop: Roadmaster Comfort Ride Leaf Spring Suspension Kit w/ Shock Absorbers - Tandem 7K Trailer Axles
- Shop: MORryde X-Factor Crossmember for Standard Frame Hangers
- Search Results: correct track
- Search Results: morryde cross member
- Search Results: morryde cross member
- Search Results: morryde suspension
- Search Results: spring hangers
- Video: Roadmaster Comfort Ride Leaf Spring Suspension Kit Installation - 2013 Dutchmen Voltage 5W Toy Haule
- Video: Review of MORryde X-Factor Crossmember Adapter Kit For Correct Track - MR93WR
- Video: Roadmaster Comfort Ride Leaf Spring Suspension Kit Installation - 2021 Grand Design Reflection Fifth
- Q&A: Does the MORryde X-Factor Crossmember Adapter Kit for Correct Track Hangers Install on Center Hanger
- Q&A: MORryde X-Factor Crossmember Fit for Standard Frame Hangers with Correct Track
- Shop: Equa-Flex Cushioned Equalizers w/ Never Fail Bushings - Double Eye Springs - Triple Axle - 3K to 6K
- Shop: Replacement Lippert Components Correct Track Axle Hanger - Qty 1
- Shop: Equa-Flex Cushioned Equalizers - Double Eye Springs - Tandem Axle - 5K to 8K - Greasable Pivot
- Q&A: Troubleshooting Brake Controller with OL Code when Brakes are Applied
- Article: Troubleshooting Brake Controller Installations
- Shop: etrailer Electric Trailer Brakes - Self-Adjusting - 10" - Left/Right Hand Assemblies - 3.5K
- Video: Hayes Engage Trailer Brake Controller Installation - 2021 Ford Explorer
- Video: Curt Venturer NEXT Trailer Brake Controller Review
- Shop: Trailer Wiring
- Q&A: Troubleshooting Curt Triflex Brake Controller Showing OL Code on Display
- Q&A: What Does The Code OL Mean on Draw-Tite Activator Brake Controller # 5504
- Article: Trailer Wiring Diagrams
- Video: Trailer Brake Controller Wire Testing
- Q&A: Troubleshooting Reese Brakeman IV Electric Brake Controller
- Q&A: Replacement Connector for a Pollak PA66-MD40
- Search Results: redarc
