Trailer Hitch for 2020 Subaru Outback That Does Not Require Removal of Rear Bumper Fascia
Question:
Per the Subaru website, the Subaru factory hitch requires that the rear bumper guard must be removed apparently permanently if you opt for the factory hitch. Do you have any hitches for the 2020 Outback that dont require permanent removal of the rear bumper guard? Also, does installing one of your hitches void any portion of the Subaru factory warranty? Thanks!
asked by: Ken B
Expert Reply:
We have hitches like the Draw Tite part # DT73RR which fit your 2020 Subaru Outback Wagon that does not replace the rear bumper beam and therefore do not require temporary removal of the rear fascia. This hitch installs below the rear bumper all together and attaches to the bottom of the chassis at the rear of the vehicle. We also have hitches that do replace the rear bumper beam like the Curt # C67JR which offer a more concealed look with better ground clearance.
The hitch also would not void the warranty of the vehicle either.
Products Referenced in This Question
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 350 lbs TW
- 3500 lbs GTW
- 2 Inch Hitch
- Concealed Cross Tube
- CURT
more information >
Product Page this Question was Asked From
Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 675 lbs TW
- 4500 lbs GTW
- 2 Inch Hitch
- Visible Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: How to Charge a Dump Trailer Battery
- Q&A: Recommended Lithium Battery Compatible Power Converter For Parallax 7355
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Recommended Hitch for a 2024 Subaru Outback
- Q&A: Is the Progressive Dynamics Lithium Converter PD4655LIV An Upgrade for the Parallax 7355
- Q&A: Recommended Replacement For A WFCO WF-8750P Power Center
- Q&A: Is There Down Side to Progressive Dynamics 4000 Series 60 Amp Over 45 Amp
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: What Size Nuts Are Needed to Connect Wires Under Hood for Brake Controller Installation on GMC Yukon
- Q&A: 05680-C Master Cylinder Replacement for Trailer Recommendation
- Article: Trailer Hitch Receiver Sizes
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: My Trailer Hitch Doesn't Fit
- Article: Trailer Wiring Diagrams