Leg/Slider Kit That Can Fit Curt Q20 Fifth Wheel Hitch

Question

Question:

The legs that go with 16530... What is their part number? Thanks

asked by: Jac T

0

Expert Reply:

The Curt Q20 fifth wheel head unit part # C16530 can fit a few leg kits depending on the application. For standard fixed legs for a long bed truck you'd want the part # C16904 or for a slider base # C16550 and you'd be set.

expert reply by: Jameson C

0

Answer 1

As long as your fifth wheel hitch was designed to fit the industry standard fifth wheel rails that are 22 inches apart then yes, the Curt X5 part #16310 that you referenced would fit your B and W hitch and work well. I attached an install video for…

view full answer...

Answer 2

Yes, the Curt Q20 legs, part #C16904, do fit on the Q24 hitch, part #C16245. The bolt holes line up and the legs are the same height. You will decrease the hitch's capacity to 20,000 pounds though.

view full answer...

Answer 3

Absolutely. The Curt #C16904 Replacement Base Legs are fully compatible with the Curt #C16541 A20 5th wheel hitch center section/hitch head.

view full answer...

Answer 4

The B&W Patriot slider fifth wheel hitch #BWRVK3270 that you referenced weighs a total of 220 lbs. While that is a lot of weight what's great about the B and W hitches is that they break down into smaller sections easily to help distribute…

view full answer...

Answer 5

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 6

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from the…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

You are correct that this refrigerator does not have an ON/OFF switch or function. The best you can do is "Standby" that draws an unknown amount of power. One option is to pull the 12-Volt fuse at the RV power center. A much better option…

view full answer...

Answer 12

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...