Will Curt Q20 5th Wheel Hitch Legs Fit the Q24 Curt 5th Wheel Hitch

Question

Question:

Will the Q20 base legs fit on the Q24

asked by: Ron F

0

Expert Reply:

Yes, the Curt Q20 legs, part # C16904, do fit on the Q24 hitch, part # C16245. The bolt holes line up and the legs are the same height. You will decrease the hitch's capacity to 20,000 pounds though.

expert reply by: Charles S

0

Answer 1

The Curt Q20 fifth wheel head unit part #C16530 can fit a few leg kits depending on the application. For standard fixed legs for a long bed truck you'd want the part #C16904 or for a slider base #C16550 and you'd be set.

view full answer...

Answer 2

Absolutely. The Curt #C16904 Replacement Base Legs are fully compatible with the Curt #C16541 A20 5th wheel hitch center section/hitch head.

view full answer...

Answer 3

The B&W Patriot slider fifth wheel hitch #BWRVK3270 that you referenced weighs a total of 220 lbs. While that is a lot of weight what's great about the B and W hitches is that they break down into smaller sections easily to help distribute…

view full answer...

Answer 4

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 5

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 6

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from the…

view full answer...

Answer 7

Most fifth wheel rails are made to the same industry standard dimensions. They aren't all though. If you measure 22 inches on center between the two rails and they look like the rails of the #RP30035 that you referenced they would be the industry…

view full answer...

Answer 8

You are correct that this refrigerator does not have an ON/OFF switch or function. The best you can do is "Standby" that draws an unknown amount of power. One option is to pull the 12-Volt fuse at the RV power center. A much better option…

view full answer...

Answer 9

To get the B&W Patriot #BWRVK3200 to work with your 2006 Dodge Ram you're going to need a set of 5th wheel rails #DM8552016-71. These rails are custom fit to your vehicle so they'll just bolt right up to the frame. It is worth mentioning…

view full answer...

Answer 10

You do not have to use a sliding 5th wheel hitch in a short bed truck. In many cases, truck beds shorter than 8 ft do not have enough clearance between the trailer and truck to execute sharp turns. This is why sliding hitches were invented. Due to…

view full answer...

Answer 11

The head alone for the B&W Companion hitch #BWRVK3500 weighs about 70 pounds. Everything else weighs about 130 pounds. So the total weight of the hitch is approximately 200 pounds.

view full answer...

Answer 12

Hey Jay. It sounds like you are on the right track here because a sidewinder pin box will be your only option for pulling your 5th wheel since you have a short bed truck with the Rambox. That said, you are right that the Reese Sidewinder cannot be…

view full answer...