Voltage Readings with the Tekonsha Prodigy P3 Brake Controller
Question:
about what output voltage should I have in a parked position
asked by: Mel
Expert Reply:
The Tekonsha Prodigy P3 # 90195 has the ability to show a few different voltages when your vehicle is parked.
The first option is your tow vehicle battery voltage which should be at least 12V if not more. The second is output power from the stoplight switch when the brake pedal is pressed which should be 0.00 when you are sitting still (or very low at the most). The third is output power to the brakes. If you are sitting still and using the brake pedal then that will read 0.00 but if you use the manual override it should gradually increase to 12V if you have your max output set to 12V.
Attached is a review video that you can check out as well as the installation instructions.
Product Page this Question was Asked From
Tekonsha Prodigy P3 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Electric over Hydraulic
- Automatic Leveling
- Under-Dash Box
- Dash Mount
- Up to 4 Axles
- LCD Display
- Up to 360 Degrees
- Tekonsha
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Brake Controller
- Shop: Tekonsha Prodigy P3 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Shop: Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Shop: Trailer Hitch
- Video: Tekonsha Prodigy P3 Trailer Brake Controller Review
- Search Results: break controller
- Search Results: 4 pin
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Wiring Diagrams
- Q&A: Tekonsha P3 Brake Controller 90195 Displays Message Output Shorted No Brakes
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: Brake Controller Installation: Starting from Scratch
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Shop: Dexter DX Series Electric Over Hydraulic Brake Actuator for Disc Brakes - 1,600 psi
- Video: Trailer Brake Controller Wire Testing
- Shop: Trailer Wiring
- Q&A: How do I Tell if the Brake Controller is Bad
- Shop: BOLT brand vehicle and hitch locks
- Shop: Replacement Brake Control Plug-In Harness for Tekonsha and Draw-Tite Brake Controller 12" Long
- Shop: Grease Seal - Double Lip - 2.125" ID - 3.376" OD - GS-2125DL
- Shop: Camco RV and Marine Handheld Showerhead w/ Hose and Hardware - White
- Shop: Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class IV - 2"
- Video: Dexter Electric Trailer Brake Kit Installation 23-26
- Q&A: How Much Power/Amps Does the Tekonsha Prodigy P3 Draw
- Q&A: Troubleshooting Tekonsha P3 Brake Controller that Constantly Shows Braking Output Reading
- Search Results: electric over hydraulic kit
- Search Results: tekonsha 3020 p
- Search Results: titan brakerite
- Video: Hydrastar Brake Actuator - Electric-Hydraulic Brake Actuator - HBA16 Review
- Search Results: brake controller
on Trailer Brake Controller
