Will Curt Trailer Hitch # 13138 Fit a 2002 Ford Ranger Edge Flare Side

Question

Question:

Will this trailer hitch fit an 2002 Ford Ranger edge with Flare side? If not , PLease recommend one to me... Thanks,

asked by: Luis

0

Expert Reply:

I spoke with my contact at Curt and he stated that trailer hitch # 13138 does fit the 2002 Ford Ranger Edge flare side. I have included a link to the installation details for you.

If you plan on doing some towing, I recommend the etrailer Ball Mount Kit, # 989900, which comes with 2 ball mounts, 2 balls, a hitch pin with clip, and a carrying bag. For wiring use Tow Ready Custom Fit Vehicle Wiring, # 118344. I have included a link to the isntallation details for the wiring as well.

expert reply by: Michael H

0

Answer 1

I recommend installing our etrailer Trailer Hitch Receiver #e29AR on your 2008 Ford Ranger 4x4 with the 4.0L 6 cylinder engine. The frame mounted receiver may require the drilling of 2 additional holes as Ford did not drill these holes in every Ford…

view full answer...

Answer 2

It is difficult to identify what hitch fits just by looking at the holes in the frame. However, I can tell you that the Curt Trailer Hitch Receiver #13138 is confirmed to fit your 2004 Ford Ranger Edge. This is a Class III hitch with a 2"…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

I agree it is the right time to upgrade to a Lithium charger/converter as not all are Lithium compatible. I recommend using the Progressive Dynamics Mighty Mini AC/DC Panel and Converter/Smart Charger - 60 Amp #PD4060K which is a replacement for your…

view full answer...

Answer 6

A TCM double-lip grease seal number 127194 has an inner diameter of 1.274-inches and an outer diameter of 1.983-inches according to my research. The available grease seal nearest to those dimensions that we offer is part #RG06-010, which is a…

view full answer...

Answer 7

I spoke with my contact at Progressive Dynamics and they informed me that the Lithium Converter for WFCO RV Power Centers part #PD4655LIV does work as an upgrade for the Parallax 7355. It has the same housing as the Replacement Converter for…

view full answer...

Answer 8

Having the extra amperage of the Progressive Dynamics Mighty Mini AC/DC Panel and Converter/Smart Charger - 60 Amp #PD4060K has no down side. You'd at worst just have more power available than you'd need.

view full answer...

Answer 9

You'd need a new panel like the Progressive Dynamics Mighty Mini part #PD4045KA which is the most similar to your Parallax 7345 except is Lithium battery compatible. There isn't a center section replacement available for what you have that…

view full answer...

Answer 10

We do have a compatible grease seal for your 168255TC oil seal, however, we do not carry rubber coated seals in this size. The 168255TC oil seal was designed to work with oil bath hubs on a 3,500 lb axle. For the most part, axle manufacturers have…

view full answer...

Answer 11

As it seems you already know, when installing a trailer brake controller on your 2007 GMC Yukon you will need to locate the two wires under the hood that need to be connected to fully activate the vehicle's tow package. One is the power wire to…

view full answer...