Can Brophy Camper Scissor Steps # SS03 be Mounted to Toyota Tacoma and Slide-In Camper
Question:
I have a Toyota Tacoma 4WD with a Four Wheel pop up slide in camper. I was wondering if the Brophy scissor step could be mounted to it in some way. What is the measurements of the mounting bracket?
asked by: Paul D
Expert Reply:
The Brophy Camper Scissor Steps # SS03 referenced in your question features mounting bracket dimensions of 18-1/4 inches wide, 1 inch tall, and 1 inch deep. The mounting bracket can be attached to any flat surface that can support the weight of the steps and a person on them, so as long as you have the space available there is no particular reason that you couldn't mount it to your Tacoma to allow for easier access to the camper.
We have had customers attach the bracket to the bottom of their camper's door frame and even to the open tailgate on their truck. I have attached a couple of these images that you can check out.
Just note that these steps are only designed to be used while the vehicle is stationary and should be removed from the mounting bracket before travel. I have attached a short video demonstration on the steps that you can take a look at as well.
Product Page this Question was Asked From
Brophy Camper Scissor Steps - 3 Steps - Steel - Diamond Tread - 17" Wide - 275 lbs
- RV Steps
- Truck Camper
- Snap-On Step
- 17 Inch Wide Step
- 17 Inch Wide
- 3 Steps
- 8 Inch Drop/Rise
- Ground Contact
- Steel
- Brophy
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Brophy Camper Scissor Steps - 4 Steps - Aluminum - Non-Slip Tread - 24" Wide - 300 lbs
- Shop: Brophy Camper Scissor Steps - 3 Steps - Steel - Diamond Tread - 17" Wide - 275 lbs
- Shop: Brophy Tailgate Scissor Step Mounting Bracket
- Search Results: steps
- Shop: Trailer Hitch
- Shop: TorkLift SuperTruss Hitch Extension for SuperHitch Trailer Hitch Receivers - 48" Long
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class V - 2"
- Shop: TorkLift GlowStep Revolution Scissor Steps w/ Landing Gear - 3 Steps - 25-1/2" Base - 375 lbs
- Shop: Lippert Manual Pull-Out Step for RVs - Triple - 7" Drop - 25-3/4" Wide - Steel - 300 lbs
- Q&A: Stairs for Getting in and out of a Truck Bed Camper in a 2005 Chevy Silverado 1500
- Search Results: electric step
- Search Results: lc3694042
- Search Results: as23
- Search Results: as24
- Q&A: Can Brophy Camper Scissor Steps # AS04 be Installed on Ram 150 Tailgate
- Search Results: tla8103
- Search Results: lc3658373
- Shop: Front Mount Hitch
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Shop: Trailer Wiring
- Article: How to Choose the Right Trailer Hitch Class
- Video: Choosing the Right Trailer Wiring
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Shop: Suspension Enhancement
- Q&A: Does Truck with 6-1/2 ft bed Have to Use Slider Hitch for Turning Clearance with Fifth Wheel Hitch
- Article: How to Measure for Trailer Hitch Drop
- Shop: Fifth Wheel Hitch
on RV Steps
