Brophy RV and Camper Steps - Truck Camper - AS24 Review Video

I went out to our warehouse to take a few measurements on the mounting bracket for the Brophy Camper Scissor Steps #AS24. The base bracket profile measures 24 inches long, 1 inch tall, and 1 inch deep. The shorter tabs that will be closer against…

The big difference is that the part #TLA7804-8000 does not come with a bracket for how it attaches to the truck whereas the part #TLA7834 does. The bracket is for a more permanent install where they'd fold up and store on the vehicle…

Sounds like you'd want to go with a removable scissor setup like the Brophy Camper Steps part #AS24 which will need to be taken off it's mounting bracket between uses. This will give you total access to your trailer hitch when…

It is too small of a space to fit the TorkLift GlowStep Stow N' Go Scissor Steps w/ Landing Gear - 4 Steps - 375lbs - Black Bracket Item #TLA7834 but you can instead mount it to the bumper of your camper like in the attached picture.

Both the Brophy #AS24 and the TorkLift #TLA7804 are easily removed when not in use- and it's actually recommended that you do so. Additionally, they both weigh in around 26-lbs total, so they're easy to move on and off; so they'd both be…

The mounting bracket of the #AS04 is 25 inches wide. The step width is 18 inches.

Yes. The TorkLift GlowStep Stow N' Go Scissor Steps w/ Landing Gear - 4 Steps - 375 lbs - Black Bracket #TLA7834 can be removed from the bracket by detaching the pull pins like the #TLA7804-8000. The main issue you might have is that the bracket…

I do have an option for you but the SolidStep Manual Fold-Down Steps are not a good fit for your 2019 Palomino Backpack HS-8801 Truck Bed Camper because they do not make any that will fit your 22" wide doorway. Instead, I highly recommend the…

If you're having trouble getting access into the bumper when installing the TorkLift GlowStep Stow N' Go Scissor Steps part #TLA7834 you'll simply need to drill an access hole large enough to fit the bolts through and then you can use a…

The TorkLift GlowStep Stow N' Go #TLA7844 weighs just over 30 (about 32) lbs by itself. The TorkLift GlowStep part #TLA7804 and part #TLA7504 both weigh a little over 20 (about 22) lbs each.

Not following the manufacturer's instructions to the letter will give them an excuse if something were to happen so while I can't recommend drilling the extra holes to ensure it's safely mounted, it's the only way that the steps will…

The bracket of the Aluminum Scissor Steps #AS04 that you referenced stays attached to the camper, but the steps themselves get removed while traveling. Check out the review video I attached for these steps as well.