Comparing Brophy CX74 and CJ74 Camper jacks

Question

Question:

What is the outside diameter of the upright pipe and inside Diameter Compared to the CJ-74? Is the CX-74 Heaver Built or Just a different Winch?

asked by: Richard M

0

Expert Reply:

While the pipe diameters are the same the rest of the Brophy Cable Camper Jacks # CX74 and # CJ74 are different. The tripod bases have different bracing and the winch mount that has the angle iron section welded to it has different bracing as well.That's why the CJ74 has a 3,000 lb capacity and the CX74 has a 4,000 lb capacity.

expert reply by: Jameson C

0

Answer 1

We don't currently have any customer submitted photos for the Brophy Heavy Duty Cable Camper Jacks #CX74, but we do for the lower capacity #CJ74, which uses the same lift brackets. From the edge of the tube to the lift bracket is…

view full answer...

Answer 2

You should be able to change the orientation of the Brophy Cable Camper Jacks #CJ74 so that the legs pointing towards the cab of your pickup and the other legs will sit under your pickup bed a little to help stabilize your camper. I have attached a…

view full answer...

Answer 3

While the Valterra Folding Manual Stabilizer for Trailers and RVs #020106 was designed for stabilizing RVs and trailers there is nothing preventing you from using it to support a slide-in truck camper. You would need at least 2 of them. Each is rated…

view full answer...

Answer 4

The Brophy Heavy Duty Cable Camper Jacks #CX74 may be able to work for you depending on the configuration of your camper. They do not have the same design in terms of fitting into the corners of your '73 Ford camper; the Brophy #CX74 uses…

view full answer...

Answer 5

The Brophy Cable Camper Jacks - 67" Max Lift Height - 3,000 lbs - Qty 2 #CJ74 don't really stick out . They hold the camper pretty much flush with the edge of the camper. I went into our warehouse to measure for you and the 2x2 inch l…

view full answer...

Answer 6

Yes, the Brophy Cable Camper Jack #CJ74 (2 jacks) or #CJ74H (single jack) does come with everything you need to jack your camper up out of your truck.

view full answer...

Answer 7

Brophy Cable Camper Jacks - 67" Max Lift Height - 3,000 lbs - Qty 2 Item #CJ74 will work great with your 1,600 pound truck bed camper. Just make sure that the 67 inch maximum lift height is enough to get the camper into the truck bed. The…

view full answer...

Answer 8

As long as the camper shell weighs less than the 3,000 lb capacity of the #CJ74 Camper jacks, you should only need one set. The lift bracket itself is 26-1/2 inches long, so be sure to place the brackets at the center of gravity of the camper shell…

view full answer...

Answer 9

If it were me I would go with the taller 67 inch Brophy jacks part #CJ74. Having more height than needed would be better than not having quite enough. Plus your truck does sit taller than most similar sized trucks so the extra height would be…

view full answer...

Answer 10

According to CR Brophy, the TDSF camper tie-down you refer to is not compatible with GM trucks after the 1988 model year. My contact tells me that the HSSF tie downs are indeed compatible with a 2012 Silverado. If you look at the provided photo, you…

view full answer...

Answer 11

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 12

Hey Travis, congrats on the new 2024 Jayco Flight 284BHS! Your travel trailer looks to have a GVWR of 7,950 lbs so I recommend going with the Equal-i-zer Weight Distribution w/ 4-Point Sway Control #EQ37121ET and pairing it with the Shank…

view full answer...

Comparing Brophy CX74 and CJ74 Camper jacks

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching