57 or 67 Inch Tall Brophey Camper Jack Recommendation

Question

Question:

Which Brophy Cable Camper jack height, 57inch or 67, would you recommend for a 2008 Tundra Crewmax 4x4? Thanks.

asked by: Eric

0

Expert Reply:

If it were me I would go with the taller 67 inch Brophy jacks part # CJ74. Having more height than needed would be better than not having quite enough. Plus your truck does sit taller than most similar sized trucks so the extra height would be beneficial.

expert reply by: Jameson C

0

Answer 1

For just the tripod base of the part #CJ31 you would want the part #1003.

view full answer...

Answer 2

Brophy Cable Camper Jacks - 67" Max Lift Height - 3,000 lbs - Qty 2 Item #CJ74 will work great with your 1,600 pound truck bed camper. Just make sure that the 67 inch maximum lift height is enough to get the camper into the truck bed. The…

view full answer...

Answer 3

You should be able to change the orientation of the Brophy Cable Camper Jacks #CJ74 so that the legs pointing towards the cab of your pickup and the other legs will sit under your pickup bed a little to help stabilize your camper. I have attached a…

view full answer...

Answer 4

As long as the camper shell weighs less than the 3,000 lb capacity of the #CJ74 Camper jacks, you should only need one set. The lift bracket itself is 26-1/2 inches long, so be sure to place the brackets at the center of gravity of the camper shell…

view full answer...

Answer 5

When the Brophy Cable Camper Jacks #CJ74 are cranked all the way down the bracket that holds the camper will be 17 inches from the ground. The bracket length is 26-1/2 inches long.

view full answer...

Answer 6

Yes, the Brophy Cable Camper Jack #CJ74 (2 jacks) or #CJ74H (single jack) does come with everything you need to jack your camper up out of your truck.

view full answer...

Answer 7

While the pipe diameters are the same the rest of the Brophy Cable Camper Jacks #CX74 and #CJ74 are different. The tripod bases have different bracing and the winch mount that has the angle iron section welded to it has different bracing as…

view full answer...

Answer 8

According to CR Brophy, the TDSF camper tie-down you refer to is not compatible with GM trucks after the 1988 model year. My contact tells me that the HSSF tie downs are indeed compatible with a 2012 Silverado. If you look at the provided photo, you…

view full answer...

Answer 9

If you're needing the 67" max lift then you can get two of the 1,500 lb version #CJ74H. Same Max Lift just half the weight capacity. If you do not really need up to 67 inches of lift, you can get the #CJ31 that will have a Max Lift of 57…

view full answer...

Answer 10

The Brophy Cable Camper Jacks - 67" Max Lift Height - 3,000 lbs - Qty 2 #CJ74 don't really stick out . They hold the camper pretty much flush with the edge of the camper. I went into our warehouse to measure for you and the 2x2 inch l…

view full answer...

Answer 11

The Brophy Cable Camper Jacks part #CJ74 can be used for storage but if the side of the camper do not extend to or past the sides of the truck bed it would not be feasible for them to be used for loading/unloading. That said, you could somehow…

view full answer...

Answer 12

The best priced pair of camper jacks we offer is the part #CJ31. If you needed a total of 4 of these jacks you'd need to order a quantity of 2 of these.

view full answer...

57 or 67 Inch Tall Brophey Camper Jack Recommendation

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching