What Comes with the Brophy Cable Camper Jack

Question

Question:

Just want to make sure if I order this that it comes with everything. Pole, handle, jack and tripod. Ive seen other sites-not your site-where someone complains that it only comes with the jack but no pole. So I want to make sure if I order this I will get everything I need to jack up my camper

asked by: George M

0

Expert Reply:

Yes, the Brophy Cable Camper Jack # CJ74 (2 jacks) or # CJ74H (single jack) does come with everything you need to jack your camper up out of your truck.

expert reply by: Erik B

0

Answer 1

As long as the bed rails on your truck are not more than 57" from the ground then you could certainly use the Brophy Cable Camper Jacks part #CJ31 to lift the camper shell up from your truck bed. Once lifted, you could just simply drive away…

view full answer...

Answer 2

The combined weight capacity of the Brophy Cable Camper Jacks #CJ31 is 1,000 lbs. I have linked the above mentioned product to this page for your purchasing convenience.

view full answer...

Answer 3

As long as the camper shell weighs less than the 3,000 lb capacity of the #CJ74 Camper jacks, you should only need one set. The lift bracket itself is 26-1/2 inches long, so be sure to place the brackets at the center of gravity of the camper shell…

view full answer...

Answer 4

If it were me I would go with the taller 67 inch Brophy jacks part #CJ74. Having more height than needed would be better than not having quite enough. Plus your truck does sit taller than most similar sized trucks so the extra height would be…

view full answer...

Answer 5

You should be able to change the orientation of the Brophy Cable Camper Jacks #CJ74 so that the legs pointing towards the cab of your pickup and the other legs will sit under your pickup bed a little to help stabilize your camper. I have attached a…

view full answer...

Answer 6

While the pipe diameters are the same the rest of the Brophy Cable Camper Jacks #CX74 and #CJ74 are different. The tripod bases have different bracing and the winch mount that has the angle iron section welded to it has different bracing as…

view full answer...

Answer 7

According to CR Brophy, the TDSF camper tie-down you refer to is not compatible with GM trucks after the 1988 model year. My contact tells me that the HSSF tie downs are indeed compatible with a 2012 Silverado. If you look at the provided photo, you…

view full answer...

Answer 8

The Brophy Cable Camper Jacks part #CJ74 can be used for storage but if the side of the camper do not extend to or past the sides of the truck bed it would not be feasible for them to be used for loading/unloading. That said, you could somehow…

view full answer...

Answer 9

If you're needing the 67" max lift then you can get two of the 1,500 lb version #CJ74H. Same Max Lift just half the weight capacity. If you do not really need up to 67 inches of lift, you can get the #CJ31 that will have a Max Lift of 57…

view full answer...

Answer 10

The Brophy Cable Camper Jacks - 67" Max Lift Height - 3,000 lbs - Qty 2 #CJ74 don't really stick out . They hold the camper pretty much flush with the edge of the camper. I went into our warehouse to measure for you and the 2x2 inch l…

view full answer...

Answer 11

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 12

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

What Comes with the Brophy Cable Camper Jack

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching