If Tailgate of Truck is Locked is BakFlip MX4 Tonneau Cover Also Locked

Question

Question:

Does this cover, the BakFlip MX4, have the ability to be locked? I ask because it can be opened with the tailgate closed

asked by: Steve W

0

Expert Reply:

Actually the only way to open the BakFlip MX4 is if you have the tailgate open. If you check out the picture I attached you'll see the release cable and that it's under the cover and only accessible with tailgate open.

expert reply by: Jameson C

0

click to enlarge

Answer 1

The BAKFlip MX4 Hard Tonneau Cover part #BAK48120 which is a fit for 2014 - 2018 GMC Sierra/Chevrolet Silverado 1500's with the 5-1/2' bed is very secure. In order to access the release string for the cover you would need access to…

view full answer...

Answer 2

There are a few differences between the BAK Revolver X2 and X4s tonneau covers. The X4s is the newest cover available by BAK, so it includes a new matte black finish on all sides, whereas the X2 will be matte on the top, and then silver on the…

view full answer...

Answer 3

The Curt Hitch Adapter #C45405 will not reduce the tongue weight of your hitch. Many adapters that extend the length will reduce towing capacity based on tongue weight, but this adapter isn't one of them. It will work fine with the Curt…

view full answer...

Answer 4

The short answer to this question is- No. The B&W Hitch Receiver Reducer Sleeve #BWRHXA2182 does not reduce the tongue weight or towing capacity of your hitch in the same manner that a hitch adapter like the #HTAD would. You will still be able to…

view full answer...

Answer 5

The sleeve adapters used adapt a 2-1/2 inch hitch to fit a 2 inch hitch accessory do not diminish the towing capacity of the hitch or the accessory installed in the hitch. We have the Curt hitch reducer part #C45405 that would work well for your…

view full answer...

Answer 6

The 7028700 reducer is a Reese Towpower product which we don't carry. The Curt reducer, part #C45405, is a similar product. I've reached out to and they definitely assured me that the #C45405 reducer is rated for weight distribution. The…

view full answer...

Answer 7

If your Class V receiver has a 2-1/2 inch hitch opening, the best adapter is the Curt Hitch Receiver Reducer Sleeve - 2-1/2" to 2" #C45405 If both the Class IV and V hitches are 2 inches, there is no adapter needed.

view full answer...

Answer 8

I have a better solution for you than a sleeve adapter. What would be better for you would be a weight distribution shank that is designed for 2-1/2 inch hitches like the #EQ90-02-4800. The great thing about weight distribution shanks is that they…

view full answer...

Answer 9

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 10

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 11

Hi there Ryan; thanks for the question and the easiest weight distribution hitch to connect and disconnect after initial set up is the B&W Continuum, with the right one for your 2-1/2" hitch being the following: - B&W Continuum Weight…

view full answer...