Pintle Hook Mount Plate and Hook Recommendation with 20k Capacity for 2-1/2 inch Hitch  

There actually won't be any bolts needed at all for the hitch plate and pintle hook you mentioned. The reason is that you will weld on the Buyers Products Fabricators Hitch Plate #3371809027A, and the mounting bolts actually come with the Pintle…

The Curt Pintle Hook for 2-1/2" Hitches - 20,000 lbs #C48010 will work for the Class V receiver but if you normally have a decent drop, you will want to still have a drop. The typical trailer coupler height of 17 inches from the ground to the…

The factory Ford 2-1/2 inch receiver has a unique corner radius that doesn't match up to anything well. You can try using a grinder to remove some of the powder coat of the Curt Pintle Hook Mounting Plate #C48348 to see if that would be enough to…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

The centerline on the #BR27FR is going to be from the center of the hitch pin hole. If you draw a line straight out and measure the distance to the bottom of the hook that is 1". I have attached a diagram below for your reference.

Yes, the Sleeve-Lock Trailer Coupler #CTA-196 will fit the channel bracket that comes with the Brophy Lunette Ring w/ 3-Position Adjustable Channel Bracket #BR43ZR. The bolt holes match as well when it comes to size and spacing so you'll be good…

The mounting holes on the B&W Pintle Hook Mounting Plate for 2-1/2" Hitches #BWPMHD14202 are 1-3/4" apart vertically and 3-3/8" apart horizontally. This measurement taken from center to center on the mounting holes.

We have just what you are looking for. I called my contact at TDE and asked about the hub you have on your boat trailer. They told me that it was a 5-stud idler hub for a 3,500-lb axle. That means you need the part #AKIHUB-545-35-K. This is a fit for…

There typically aren't any part numbers stamped onto the trailer spindle that can be used for identification. There are however numbers stamped onto the hub most times which can be used for identification. The TDE46210 tells me you have a 3,500…

Though we do have the Bearing Buddy #BB2441T-SS that is a direct replacement for Tie Down's Turbo Lube oil baths, this will require you changing over to grease instead of oil. With that said, we do also have the Kodiak XL ProLube Kit…

The Curt Pintle Hook Mounting Plate for 2-1/2" Hitches #C48239 has a solid shank, which helps provide for its robust 18,000 lb capacity. To secure it to your 2-1/2" hitch you will need either the Hitch Pin and Clip #325-GH-099 or Trailer…

The factory 2-1/2 inch receiver on the Ram and Ford trucks have more rounded corners whereas the Titan pintle hook mounting plate, #RP45294 has corners that are more squared. As a result, they tend not to fit together unless you remove some of the…