Is Mounting Hardware Needed for Buyers Products Fabricators Hitch Plate & Tow Ready Pintle Hook  

If the trailer hitch has a 3/4" diameter hitch pin hole then that is what you'll need to use when towing with said hitch even when using an adapter such as the Curt Hitch Receiver Reducer Sleeves part #C45408. If you don't have a…

The Pintle Hook #C48215 that you referenced does include mounting hardware to attach to a pintle hook plate like the Super Titan Forged Pintle Hook Plate #RP38186 that you referenced. I also pulled these two parts and was able to determine that they…

The Curt Pintle Hook for 2-1/2" Hitches - 20,000 lbs #C48010 will work for the Class V receiver but if you normally have a decent drop, you will want to still have a drop. The typical trailer coupler height of 17 inches from the ground to the…

The factory Ford 2-1/2 inch receiver has a unique corner radius that doesn't match up to anything well. You can try using a grinder to remove some of the powder coat of the Curt Pintle Hook Mounting Plate #C48348 to see if that would be enough to…

For a pintle mounting plate with a 20k capacity that is designed to fit a 2-1/2 inch hitch we have the Buyers Products part #337PM25812 as the Curt you mentioned only has an 18k capacity. Then for a hook to bolt onto this we have the part #C48215…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

We aren't manufacturers of those parts, and we don't have the testing ability in house, so I reached out to a couple of our manufacturers to see what information they could provide to try and help. I reached out to my contact at Curt…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

Yes, they do. The Firestone Ride-Rite Red Label Extreme Duty Air Helper Springs item #F95FV will fit the dually and single rear models of the 2024 Ford F-350 4WD. These air bags have a 7,500 lbs capacity that will level out the rear end of your F-350…