Could Optronics Clearance Light # ST70RB Fit Polaris PU5X16-RW

Question

Question:

Will your Optronixs Light ST70RB fit a Polaris PU5X16-RW trailer?

asked by: Wilsey K

0

Expert Reply:

I am sure you could fit the Sealed, 6-1/2" Oval Trailer Stop, Turn and Tail Light # ST70RB on your trailer but I couldn't find a decent enough picture of your trailer to determine if it does use a similar light or not.

I attached a dimension picture though for this light for you to compare to what you have on your trailer to see if it's an exact fit or not.

For a grommet to install this in a trailer flush (assuming yours is different) you'd want # A70GB. Or for a mounting bracket you'd want the part # BK70BB.

expert reply by: Jameson C

0

click to enlarge

Answer 1

The easiest way to cut the oval hole for the Rubber Grommet, #a70gb, in my opinion, would be to use a Light Mounting Bracket for 6-1/2 inch Oval Trailer Lights, BK70BB, as a template and then use a hole saw the correct size to cut a hole on each…

view full answer...

Answer 2

The Optronics light that you referenced, part #ST70RB, is an exact replacement for Bargman light #40-06-001. If you can find that part number on your Bargman light, then we can be sure that this light is the correct replacement. Even if your…

view full answer...

Answer 3

The brake controller port on a 2021 Ford F-150 (if equipped) will be located behind the coin tray in the center console. This will be accessed by removing the panel under the steering wheel. I have attached a video which shows this below. For a…

view full answer...

Answer 4

The 125255UC seal has a 1.249" ID and a 1.983" OD and for that our part #34823 will be the correct replacement.

view full answer...

Answer 5

Yes, the J-60 light is a 6-1/2 inch wide by 2-1/4 inch tall light that is 2-1/4 inches deep overall so the Sealed, 6-1/2 inch Oval Trailer Stop, Turn and Tail Light, 3-Function, item #ST70RB, is a direct replacement for your light. If you need a…

view full answer...

Answer 6

Having the puck system is a great feature. If you ever plan on loading the bed with mulch, sand or rock you'll quickly find that having rails permanently bolted to the bed floor is a real pain. Not only that, but the pucks look a lot…

view full answer...

Answer 7

Furrion unfortunately does not sell their connectors separately for some unknown reason and I haven't seen any Y-adapter connectors like you'd see with any other system. When it comes to connecting them together the only way to is in…

view full answer...

Answer 8

Yes, you can weld on the Dexter DX7.5L A-60 Brake Actuator w Electric Lockout - Bolt On - Disc - 2" Ball - Zinc - 7.5K item #DX56FR you referenced. You will want to make sure you remove the zinc coating and get down to the bare metal. I…

view full answer...