Optronics Trailer Tail Light Review Video

First thing you should do at this point is test the pins of the trailer wiring harness with a circuit tester part #PTW2993 for voltage on all of the right pins when the taillight signals are being applied. Just like in the video I attached. If the…

I checked with Ranger and the current generation of the Trailer RT188 uses the 6 inch oval tail lights. For those the Miro-Flex Trailer Tail Light #STL22RB is a great option for an LED upgrade. These lights use pigtail #A47PB and will fit the mounts…

Based on the picture you submitted it looks like you are looking for the part #STL22RB which is an LED version of the light you have that has 12 light emitting diodes.

Yes, you just have to remove the old lights, match the wires and mount the new ones. Please note, that it is usually not a good idea to mix LEDs and incandescent lights, so if you have have side markers or other lights on the trailer, make sure you…

The two lights you mentioned are essentially the same with the only difference being the amount and size of the diodes. The part #STL22RB has 12 larger diodes and the part #STL70RB has 48 smaller diodes. I attached review videos for both lights for…

When replacing your 6-1/2 inch oval tail light like the Optronics Sealed #ST70RB that does not have any visible screws on your boat trailer, you can remove the assembly by simply pulling it out of the existing grommet. You can wiggle it back and…

Yes, we do have a hitch that will fit your 2022 Honda CR-V Hybrid Touring. It is the EcoHitch Hidden Trailer Hitch Receiver item #306-X7345. This hitch is custom fit and bolts directly to your CR-V's frame with included hardware. If you look…

For a Bobcat 331 that weighs up to 7,500 lbs I'd recommend the 10k ramps part #325-GH-R96 that you referenced which are 96 inches long and 15 inches wide. I attached a picture of a heavier tractor being loaded with these ramps as well as a review…

Because the GloLight LED Backup Light for Truck or Trailer part #BUL111CB slightly diffuses the light around the outside of the light I recommend using the LED Backup Light for Truck or Trailer part #BUL10CB. This will give you a slightly brighter…

If the controller is working fine with one trailer and not with the other then the problem is most likely with the trailer and not the truck. I would start by checking all of the ground connections on the trailer, especially the ground at the coupler…

For a replacement light that is the same size as your ST70RBTK I have two options. One is the Optronics Trailer Tail Light - Stop, Turn, Tail - Submersible - Incandescent - Oval - Red Lens #ST70RB and the other is the Optronics LED Trailer Tail Light…

It is not likely that the clearance lights, #MCL95RB, are the issue since they ground through the mounting hardware and only have one power wire that goes to the running light circuit. Still it is worth checking to make sure that the grounds are…