Roller Bunk # DL21754 Recommendation for a Flatbed Trailer Converted to a Part-time Boat Trailer

Question

Question:

I need some rollers to mount to the back of my flatbed trailer so that I can use it part time as a boat trailer. My V-hull boat only weighs 235#. Do you have something that can cover about 3 or 4 feet of the back that I can use for this purpose? I intend to make it removable for what not using this trailer for my boat.

asked by: JAmes

0

Expert Reply:

Yes, I would recommend you get Boat Trailer Standard Roller Bunk, part # DL21754, for hauling your boat that weighs 235 lbs in your flatbed trailer. These are sold in 4 foot sections and should work well for you once installed.

You may be interested in Boat Trailer Roller Bunk Bracket # DL21762 for when you install the roller bunks in your trailer.

expert reply by: Jameson C

0

Answer 1

The Kenda Karrier ST205/75R14 Radial Trailer Tire #AM10235 (Load Range D) and the Kenda Karrier ST215/75R14 #AM10229 (Load Range C) that you referenced are simply different tire sizes. The ST215/75R14 tire size is larger in diameter/height by just…

view full answer...

Answer 2

Well, that is going to depend on several factors. Roughly, very roughly, it would be 3/5 of the way back from the front. But there is more to it than that. There is a bunch of basic math involved. Like you wanted, I have included a picture that…

view full answer...

Answer 3

The step height for the Jif Marine Hinged Dock Ladder - 5 Steps - 750 lbs - Aluminum - 4" Deep Step #JIF67FR is 12". This is the same as the rung to rung measurement. In other words, each step is 12" apart.

view full answer...

Answer 4

That's not a number we are familiar with. What's the inner diameter of the bearing? If it's 1 inch most likely you have a L44643 and the 6 just happens to look like a 5.

view full answer...

Answer 5

In regards to the CE Smith Outboard Motor Dolly part #CE27580, the mounting board measures 16-1/8" long x 1-1/2" wide. which you can see in the photo attached below.

view full answer...

Answer 6

I pulled one of the part #DL13800 couplers from the warehouse and took a few measurements. I have attached a photo of the coupler with the dimensions noted you can check out. The critical measurements you mentioned such as the holes from the bottom…

view full answer...

Answer 7

The inner piece of CE Smith roller #CE29560 is nylon. These pieces are usually just in a few inches at the ends of rollers for extra support and don't go through the hole length of the roller. For a shaft for this roller you can use #CE10705A…

view full answer...

Answer 8

You may be able to use the 12-3/4" x 1/2" Roller Shaft with Pal Nuts #CE10705A with the Yates Side Guide Roller 12" Long - 1/2" Shaft #YR12243-4P, but it won't give you much space to work with. A better option is to use the…

view full answer...

Roller Bunk # DL21754 Recommendation for a Flatbed Trailer Converted to a Part-time Boat Trailer

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching