Using a 2 Inch Shank Bike Rack on a 2017 Volkswagen Golf

Question

Question:

I have a bike rack that needs a 2inch reciever. any such thing available? the online tool only returns 1 1/4 for that vehicle... thanks!

asked by: Larry

0

Expert Reply:

I have a possible solution for you, but unfortunately there is not a 2 inch receiver available for the 2017 Volkswagen Golf.

You have the option of using a hitch expander like the Brophy 1-1/4 inch to 2 inch expander, part # HTAD, but this will reduce the available tongue weight by 50 percent, possibly rendering the rack unusable.

expert reply by: Jacob W

0

Answer 1

An extender will reduce the capacity of the hitch, not your bike rack, by 50 percent. Your hitch is rated at 200 pounds maximum tongue weight, if you were to use an extender, your tongue weight capacity would be reduced to 100 pounds. Subtract 55…

view full answer...

Answer 2

For a hitch adapter that will work well with the Curt Class I Trailer Hitch Receiver #C11482 that you referenced, I recommend the Brophy #HTAD. This is compatible with Class I hitches and will convert the 1-1/4 inch receiver to a 2 inch receiver…

view full answer...

Answer 3

The 1-1/4 inch hitches available for the 2007 Honda Element SC are Class I hitches with a 200 lb tongue weight rating. I researched the Kawasaki KLX 140 dirt bike and it weighs 205 lbs. Your existing hitch is overloaded with just the weight of the…

view full answer...

Answer 4

It sounds like you have a smaller hitch receiver on your 2019 CX-5 and have a 2 inch shank on your bike rack. The best option is to use the Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2" #76138 which will work perfectly…

view full answer...

Answer 5

Hi, great question and the short answer is no. While per manufacturers specs it is not required to use a stabilizing strap with the Draw-Tite #36493, use of one is a judgement call that really depends on your situation. Please consider the weight of…

view full answer...

Answer 6

When you use an adapter in a trailer hitch it decreases the capacity of the trailer hitch by 50 percent. Also, a 1-1/4 inch trailer hitch will only allow you to be able to carry 2 bikes. If you are carrying 2 bikes on your vehicle I recommend part…

view full answer...

Answer 7

Yes, there adapters you can use. The Hitch Adapter 1-1/4" to 2" Trailer Hitch Receiver, part #HTAD, will fit your 1-1/4" trailer hitch. Adding a hitch adapter may be problematic because it reduces the maximum tongue weight of the…

view full answer...

Answer 8

Yes we do. The part #HTAD is an adapter designed to adapt a 1-1/4 inch hitch to a 2 inch hitch. You should note that adapters like this cut the capacity of the hitch they are used on in half. I attached a review video for this adapter plus a help…

view full answer...

Answer 9

To confirm the measurement from the end of the 2 inch section to the center of the pin hole of the 1-1/4 inch section, I pulled the Brophy Adapter #HTAD that you referenced an found that it measures 2-3/4 inches. I have that figure noted in the…

view full answer...

Answer 10

We offer 1-1/4 inch to 2 inch hitch adapter, part #HTAD. However, using any adapter will lower the tongue weight capacity of your hitch by half. When using this adapter, you will only be able to carry 100lbs on the hitch, including the weight of the…

view full answer...

Answer 11

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 12

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Using a 2 Inch Shank Bike Rack on a 2017 Volkswagen Golf

Product Page this Question was Asked From

Continue Researching