Hitch Adapter Recommendation for Converting 1-1/4 inch Hitch to 2 inch Hitch

Question

Question:

Do you have something to convert my hitch from 1 1/4inch to 2?

asked by: Mike

0

Expert Reply:

Yes we do. The part # HTAD is an adapter designed to adapt a 1-1/4 inch hitch to a 2 inch hitch.

You should note that adapters like this cut the capacity of the hitch they are used on in half.

I attached a review video for this adapter plus a help article on adapters like this for you to check out as well.

expert reply by: Jameson C

0

Answer 1

To confirm the measurement from the end of the 2 inch section to the center of the pin hole of the 1-1/4 inch section, I pulled the Brophy Adapter #HTAD that you referenced an found that it measures 2-3/4 inches. I have that figure noted in the…

view full answer...

Answer 2

I do have a solution for you but adapter #853-7489 does not fit the T2 TH9045. What you can use (and what is basically the same thing only it doesn't attach to the bike carrier) is a reducer sleeve, #HT02. Pin the reducer into the hitch…

view full answer...

Answer 3

There are several different classes of 1-1/4-inch hitches offered for the Subaru Forester. Without knowing the vehicle's model year I cannot be absolutely sure if the hitch on the vehicle is a light-duty Class I type or a higher capacity Class…

view full answer...

Answer 4

It sounds like you need to know how deep the inside of the receiver tube of the EcoHitch #306-X7601 for your 2018 Subaru Outback is. I went out to the warehouse and measured right at 6 inches. I've also attached a video of the hitch being…

view full answer...

Answer 5

The pin hole on the EcoHitch Hidden Trailer Hitch Receiver part #306-X7601 is just over 2" from the end of the receiver. There is then 2" from the pin hole to the back of the receiver tube opening.

view full answer...

Answer 6

The EcoHitch part #306-X7601 that you referenced is the best option for a trailer hitch for your 2018 Subaru Outback Wagon. I really like it as it does not require the stabilizer strap like the Curt does and because only the hitch opening will be…

view full answer...

Answer 7

Yes, for your 2019 Subaru Outback Wagon we have the EcoHitch Hidden Trailer Hitch #306-X7601, which like the models you have seen on other vehicles features a sleek hidden crosstube design that allows only the 2" receiver to be visible (see…

view full answer...

Answer 8

We offer 1-1/4 inch to 2 inch hitch adapter, part #HTAD. However, using any adapter will lower the tongue weight capacity of your hitch by half. When using this adapter, you will only be able to carry 100lbs on the hitch, including the weight of the…

view full answer...

Answer 9

Yes, there adapters you can use. The Hitch Adapter 1-1/4" to 2" Trailer Hitch Receiver, part #HTAD, will fit your 1-1/4" trailer hitch. Adding a hitch adapter may be problematic because it reduces the maximum tongue weight of the…

view full answer...

Answer 10

I have a possible solution for you, but unfortunately there is not a 2 inch receiver available for the 2017 Volkswagen Golf. You have the option of using a hitch expander like the Brophy 1-1/4 inch to 2 inch expander, part #HTAD, but this will reduce…

view full answer...

Answer 11

When you use an adapter in a trailer hitch it decreases the capacity of the trailer hitch by 50 percent. Also, a 1-1/4 inch trailer hitch will only allow you to be able to carry 2 bikes. If you are carrying 2 bikes on your vehicle I recommend part…

view full answer...

Answer 12

An extender will reduce the capacity of the hitch, not your bike rack, by 50 percent. Your hitch is rated at 200 pounds maximum tongue weight, if you were to use an extender, your tongue weight capacity would be reduced to 100 pounds. Subtract 55…

view full answer...

Hitch Adapter Recommendation for Converting 1-1/4 inch Hitch to 2 inch Hitch

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching