Fender Compatible With 13 Inch Wheels On Shorelander Trailer Carrying 18 Foot SEA-ARC Boat

Question

Question:

I have a 18 ft SEA-ARC boat on my shorelander trailer . My problem is that the pictures shown do not show the inside of them. My trailer has a angle on the inside because of the flat bottom being a shallow draft boat. I think I have 13inch tires because of the weight. It looks like it is about a 30 degree angle.

asked by: Gary M

0

Expert Reply:

I have provided a link of the fenders that will work with your existing trailer and a 13 inch tire size. Several of these fenders provide areas that are intended to mount lights but none have lights that are included with the fenders. For your trailer I recommend the Fulton Single Axle Trailer Fender with Top and Side Steps, this comes in 3 colors white # F008573, silver # F008593, and black # F008583. The dimensions of this fender are 9 inches wide by 40 inches long by 12 inches tall. It is made of high-density polyethylene, is corrosion proof, impact resistant and has a built in side and top step.

If you have a Jeep style fender, you can use the steel # HP76VR or the aluminum # HP96VR with your 13 inch wheels.

For a light you can use the Left Fender Clearance Trailer Light, Prewired - Amber and Red # BA44FNL and # BA44FNR to match.

Unfortunately no pictures came through, so I used what I could find to help.

expert reply by: Jason S

0

Answer 1

In regards to the CE Smith Single Axle Trailer Fender part #CE19503, this fender is designed to be used with 13" diameter wheels. The manufacturer does not provide specific measurements of the opening inside but rather the size of wheel that…

view full answer...

Answer 2

I went out to our warehouse to take a look at both the CE Smith Single Axle Trailer Fenders - 12" Grey #CE19502-2 and the larger 13" Black #CE19503-2. Both options represent the only color available from CE Smith in the respective…

view full answer...

Answer 3

I went out to the warehouse to measure the CE Smith fenders #CE19503. The opening of the wheel well is approximately 27.5 inches long. I also took a picture of the underside for you.

view full answer...

Answer 4

I was able to find some photos online for a 2005 Lowe Boat Trailer and it looks to use the Fulton Single Axle Trailer Fenders with Top and Side Steps like part #F008593. I am not sure which exact size or color you need but I have attached a full…

view full answer...

Answer 5

Yes, the trailer fender part #CE17100ATB can be used on a trailer with 13 inch wheels. Basically we have wheel size suggestions for the fenders we carry but the best way to verify fit is to check the dimensions and make sure they'll fit.…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13…

view full answer...

Answer 8

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 9

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 10

There is a flange on the Tandem Axle Trailer Fenders w/ Backing Plates #HP82VR that overlaps the backing plate that you'll use for the welding surface. When it comes to welding, we always recommend having this done by an experienced welder.

view full answer...