2006 Toyota 4Runner Brake Controller Install Port Location

Question

Question:

I found the taped up connector, however, there are two white connector blocks taped up, one is wider than the other.. which one do I use and what is the other one for? Thanks.

asked by: Bob

1

Helpful Expert Reply:

I attached a picture that shows which connector to use as well as an install video that shows the # 3040-P being used to install a brake controller in a similar 2004 4Runner.

expert reply by: Jameson C

1

click to enlarge

Answer 1

I believe that the Redarc Liberty Brake Controller #RED24FR is hooked up correctly to your 2017 Subaru Outback. The blue light flashing when you push the override button is telling you that a trailer is not connected. Also remember that with this…

view full answer...

Answer 2

Since the Redarc Tow-Pro Elite Trailer Brake Controller - 1 to 3 Axles - Proportional #RED44FR you have does not have any lights you are correct that it is not recognizing that a trailer is connected. What you will need to do is inspect the 7-way…

view full answer...

Answer 3

According to the troubleshooting section of the instructions the controller is telling you that the black power wire is not getting the 12 volts of power from the vehicle. This happens if the in line fuse or circuit breaker goes bad. Double check…

view full answer...

Answer 4

I have noticed that the Toyota vehicles all require mounting the seemingly extra ground wire under the dash of the vehicle when installing the Tekonsha Brake Controller Wiring Harness for Pre-Wired Toyota and Lexus Vehicles, item #3040-P. I always…

view full answer...

Answer 5

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 6

We always suggest avoiding any drilling or alteration of a hitch if at all possible. We do offer a no-drill mounting bracket extension that attaches to a hitch with a steel ring clamp, but due to the very large size of the main tube on this hitch the…

view full answer...

Answer 7

The correct replacement for a Demco Master Cylinder 05680-C is the Replacement Master Cylinder part #5650. I spoke with Demco to confirm this for you.

view full answer...

Answer 8

The correct replacement master cylinder kit we have for your Demco setup is the part #DM5918 which comes with the lock out replacement.

view full answer...

Answer 9

The Tekonsha OEM Vehicle Wiring Harness #22121 that you referenced includes all the wiring and parts necessary to install a fully functional 7-Way connector and trailer brake controller. The included brake controller harness is compatible with and…

view full answer...

Answer 10

The different size Equal-I-Zer systems have heads to match the bar sizes so the parts are not interchangeable. But not to worry, with some adjustment you can soften it up a little and not have to use a different system. You will need to lower the…

view full answer...

Answer 11

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

view full answer...

Answer 12

The Bargman LED, Recessed, Double Taillight #47-84-527 is designed to go on either the left or the right side of your trailer. You would wire it up to the trailer wiring by function. So, if you were installing this on the driver side of your trailer…

view full answer...

2006 Toyota 4Runner Brake Controller Install Port Location

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching