Elbow combines waste valves and pipes into one outlet. 3" Flange bolts onto black-water valve. 1-1/2" Flange bolts onto gray-water valve. 2" Hub slides onto sewer pipe. 3" Lug fitting makes it easy to connect to your sewer hose.
Features:
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Today we're going to take a look at the Valterra RV Three Way Sewer Elbow. It has the three inch bayonet end, the two inch hub inlet, the one and a half inch rotating flange end, and the three inch rotating flange end. Now this is a three way sewer elbow that is made of a durable ABS plastic construction. This part is used in your black water system of your RV. We'll start with the bayonet end. The bayonet is the one that would have the four pins on the end right here. What that does, is it allows a cap to be able to put on and twist it into place.
Usually the cap will have two hooks on it, or a sewer hose that will have four hooks on it, that when you put it on you just twist it onto the pins. It supplies a nice, secured connection. Just to give you idea, I happen to pull a cap. You can see it has the two hooks, so all you have to do is when you put the cap on, if you just twist this, you can see as you twist it, it will lock it into place and give you a nice, secure connection. As I mentioned you can also do that with the sewer hose. Now the rotating flange ends, what's nice with those, once they're installed completely, it will still allow the elbow to rotate after these flange plates are all connected to their connections.
Now I do want to give you some measurements on this. We are going to start with the internal measurement on the bayonet end. The internal measurement on that is going to be right at three inches. Now we'll go over to the hub inlet side. Internal dimension on that is right at two and three eighth inches.
Now on the rotating flange end, we'll start with the three inch internal dimension. That's going to be right at three inches. On the flange itself, I'm going to give you the measurement of the mounting hole center to center, is three and three quarter inches. Then we'll go over to the smaller one. This is the one and a half inch rotating flange end.
Internal measurement is one and a half inches. The measurement on the mounting holes on that flange is right at two and a half inches center to center. That should do it for the review on the Valterra RV Three Way Sewer Elbow with the three inch bayonet end, the two inch hub inlet, the one and a half inch rotating flange end, and the three inch rotating flange end.
Do you have a question about this RV Sewer Hose Fitting?
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.