Roller Shaft w/Cap Nuts 19" x 5/8"

I have ordered several times over the years for trailer parts and have always been very satisfied with the quality and customer service I have received. This order for several parts was no different. when I need parts I know I can find what I need at E Trailer. Shipping is fast and reasonably priced. Very satisfied.1689518

I HAVE NOT RECEIVED THE 5/8 19" SHAFT. THE 18" ROLLER ARRIVED WITHOUT THE SHAFT IN THE CONTAINER!When may I anticipate it arriving?1640319

Brooke M.

8/9/2023

It looks like your order was split. I will have our customer service team reach out to you about this in more detail!

Did exactly what I needed it to do. 1696593

Everything was exactly what I needed and pretty fast ship!1646665

by: Dean A06/24/2017

Hi Etrailer.
What happened to George who wrote me about this about a year ago. Anyway you will figure it out.
This has been a slow project because I am an old retired guy living on a surfing beach way down in Mexico. I brought all the parts from you down in my truck about two years ago. All the parts came from you and the steel and paint I bought here in Mexico. I built the trailer in my shop here and had to modify it several times to fit the strange requirements we have for launching off the beach with waves. I never seem to remember to take the camera or my phone to the beach to show that procedure but it is a little involved compared to a tilt trailer on a boat ramp. If I back the trailer into the water the wave action washes the sand out from under the trailer tires and the quad tires and them I am stuck. I have to launch in the hard sand just inland from the waves and parallel to them. The trailer can only tilt until the rear cross member is just above the sand or I cannot pull the trailer out from under the boat with the 500 lb. Honda 4WD quad. We put pieces of 2 inch black irrigation plastic tubing about 6 feet long under the boat as it is coming down off of the trailer as it is pulled out. This gives us old guys the chance to push the boat 90 degrees until it faces the waves. We wait for some larger waves to roll up under the boat and then we push it into the water and away we go when we find a lull in the incoming waves. We use the boat to get to surfing spots and then fish on the way home. The trailer pictures I am sending are showing the tilt stop that is not quite in use as I am just running the engine in my drive way. The fat little tires are for the sand.
If this project is of interest to you I have some pictures showing the construction of the trailer that better show some of your hardware. I will also try to remember the camera the next time we launch. Our waves are bigger in the summer time so we will have to wait for a small surf day to play with the boat.
Everything that happens here in Mexico is slow and there was some spine surgery that also slowed things down a bit. But a year later I am still surfing and playing with the boat.
That's my story and sorry to be so slow.
Dean Aldinger
Casa Margarita
Playa La Saladita
Guerrero Mexico. 398414

As advertised. 1636846

The roller shafts were high quality, met specifications and were as illustrated. They worked well with the brackets I ordered, and are a perfect fit with the 18 inch rollers I ordered. What I appreciated just as much as the product, was the high level of service that I received. The etrailer.com staff seemed genuinely concerned with me being happy with the order. I will definitely buy from etrailer.com again when I have need for the products they offer.100270

Repairing a tandem axle boat trailer for 1987 Grady White, I found the keel roller, shaft, and guide rollers on back had deteriorated. Locally I could only find the "Heavy Duty," but needed the Super Heavy Duty. After a couple of failed attempts locally, I found the necessary items on eTrailer and had them delivered to my door-- promptly. Further, right before ordering I noticed a flat tire. Although I was able to get a new one mounted on that galvanized rim locally, I decided a spare would increase my comfort level when towing, so had one included in the eTrailer order. Now ready for fishing season.332077

No problems fit well and works fine. Just a roller shaft. I wish it came in stainless, though. My only suggestion to other customers would be to know that this has to be ordered separately, it does not come with the keel roller and/or the brackets. I ordered these and then realized the shaft was not included and had to order it and wait a few more days to get the job done. Pretty much my own fault. 97926

by: Dennis05/14/2021

Came with the 18" roller. However 19" is just a bit too short. Not enough exposed shaft for the retainer caps to get a grip. Had to drill it and pin it after it all fell apart at the boat launch.1037324

Put in an order with several items I needed, so it came to over $99 so I get free shipping. 2 of my items were not in stock, But I needed the other items. They made me cancel the first order, then submit another with the in-stock items. I came to under $99 so I had to pay shipping. etrailer would not just send me what they had in stock and the rest later with free shipping. Not very consumer friendly.1330546

All of your products were of very good quality and fit perfectly the first time. Thank you for being genuine. I especially appreciate you selling Dutton Lainson products, as I grew up in Hastings, NE. They are a very good manufacturer.812295

by: Marat01/04/2022

etrailer ask me for a review about these items. I all forgot about them. They were what I wanted and exact same as old parts. So far they performed OK1236526

Shaft was the right width but not the right length. With 1/4” steel supports holding the shafts, I had to tack weld the shafts in place. The caps sent were useless.1364779

by: Bill B.04/29/2019

The products worked as advertised and functioned well for my application. They were easy to install. etrailer's prices were very competitive and their service was outstanding. 635663

Great delivery time 1583471

by: Hawk03/31/2019

Purchasing theses items from etrailer was fast and extremely convenient . Quality items at a very reasonable price. I am totally satisfied with my purchase and will uses etrailer for any future trailer needs.
615781

We ordered hull rollers for our boat trailer. They were as nice as expected and arrived much sooner than expected. Great experience.214512

Nice product. Worked well for the older trailer. We had to cut it down from 19" to 13" to fit, but all went well. Received our order quickly and item was much less expensive than retail. Would purchase from this site again. Thanks!154056

They where great on providing information on the questions I had order was easy and package got here in a reasonable time918005

Order was received earlier than anticipated. The 19” roller shaft was too short. I did not realize it had to be longer to accept the outer roller. Overall excellent.1290388

ALL PARTS WHERE CORRECT I INSTALLED THEM ON MY TRAILER TODAY. THANKS FOR THE GOOD SERVICE.
JIMMY98477

Does what it should do. End caps hold well. Great product 514656

Well made rollers, prompt service.
I will use etrailer products again.850530

Wish they came in stainless and came in multiple lengths. These will need to be cut to 14”977269