Get a clean look and a secure hold for your Taylor Made Big B boat fenders with these nylon locks. Simply clamp the 2 sides of each lock around the end of the rope and insert into the fender's center tube - no need to tie any knots.
Features:
Specs:
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Today we're going to take a look at the Taylor Made Big B Fender Hangers, in a quantity of three. Now, this clip will attach to the rope that's at the bottom of your fender to secure it without having to tie a knot. And it is designed for use on the Taylor Made Big B Fenders, with the three quarter inch inside diameter center rope two measurements. I happened to pull one of those just to show you what we're talking about here.This is one of the Big B Fenders, and you can see here's the rope that's at the bottom. So, what you do end up doing with this is you put your rope.. This is a three-eighths inch diameter rope.
You just put that on top of one of the halves, put the other half on top of that, and then you push them together. And then what you do is insert it into that hole, and you just push it all the way in and twist it, and it'll fully insert it into the fender.Now, these clips may be used on other brands, but due to the variation among different brands you must verify that there's a tight enough fit between the tube and the product for a nice proper function. Basically, the center tube in the fender must be small enough to keep the product halves firmly together.Now, these hangers here, they are an injection-molded reinforced nylon for strength. Basically, the hanger clip keeps that rope from deteriorating in the water. Also, these hangers are vented to prevent water accumulating in the fender, too.
And as I showed you, they do fit the three-eighths inch diameter ropes. And, what's nice about that is, when you do add this, it gives a nice finished look to the boat bumper by covering that cord that's dangling at the bottom of it. And again, it is for a quantity of three clips.But, just to show you again, you put your rope right in there. Put your half in there. Put the two halves together, and then you just insert that and twist it until you get it where you want it.
It's almost like a screw. And you can see, just like that, gives a nice finished look at the bottom. But that should do it for the review on the Taylor Made Big B Fender Hangers, for a quantity of three..
Average Customer Rating: 5.0 out of 5 stars (3 Customer Reviews)
Get a clean look and a secure hold for your Taylor Made Big B boat fenders with these nylon locks. Simply clamp the 2 sides of each lock around the end of the rope and insert into the fender's center tube - no need to tie any knots.These are very handy. Work well in the large fenders. Suggest you keep extras around. If you put a ton of stress on them, the rope will pull out and strip the grips. But that is WAY better than destroying your $[XX] fender. Which is what happened to me before I bought these. These will give out prior to busting the fender, but can still take a lot of stress.
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.