Replacement Strainer and Swivel Connectors for Flow Max RV Fresh Water Pumps

Video Transcript for Lippert Components Flow Max RV Fresh Water Pumps Strainer and Swivel Review

Today we're going to be taking a look at some replacement parts for your Lippert Components Flow Max water pumps. So this kit's going to come with two of these ends, and this is going to have an outer diameter of half an inch. So the tubing you want to use with this is a half inch inner diameter tube. So once you take this tube, it's the right size. And we do have some clamps on our websites that you're gonna need, because this is not a good enough seal, especially with all that pressure. So definitely grab some hose clamps from our website when you grab this kit.

So we're going to have that on both sides and depending on how your system's set up, you don't really have to worry about it not threading into all the different pieces. One thing we'd need to put on here is thread tape. We do have that as well. So pick that up with your hose clamps and your hose whenever you grab this. And if you are just replacing it just because it maybe cracked or whatever, these are going to work, which is good.

So mainly what you want to do is on the inlet side, we're going to put the strainer slash filter and it'll thread right on there. And it's threaded the same as the other side. So the other little replacement part will go right up on there, but it all just depends on what your setup really does and what it really looks like. So a lot of the times with the hard line PVC fittings, it's a hard pipe. So we actually didn't use these.

I've installed all of these on one of our campers. And we never really use this until we installed the accumulated tank. So just be mindful of that. Onto the filter, we do have a filter in here. So there's not a replacement for this filter.

All you gotta do is just wash it out. That's what I like about the non-paper filters. You can just use them and they'll last pretty much forever. So that's basically what you get and what I've really found. So if you take a look at all of these water pumps, this is every single water pump that we sell here. So there's replacement parts for all of them, and we have them on there right now. But if you notice, there is no difference between the HydroMax and the Flow Max and the Seaflo. So if you really are in a pinch and you need this part and one of them is out of stock for whatever reason, they're all threaded the same, they're all the same size. And they all do the exact same thing. So, obviously if you have a Flow Max, grab the one for the Flow max, but it really doesn't matter because they are all the same exact thing. But the only thing I would really add to this, if you are just replacing that, make sure you have an accumulator tank on your camper, definitely helps just keep the noise down and stuff, and you can use this without as well, but also just grab the tubing and thread tape and the clamps. And that'll do it for our look at the replacement parts for your Lippert Components Flow Max water pump..