Ultra-Fab Motor Homes Slide-Out Supports Review Video

I went out to the warehouse and took some measurements of the top of the Ultra-Fab Slide-Out Supports, #UF19-960002. The inside width is 4-3/4 inches. The outside width is 5 inches. The height is 1-3/8 inches and the front to back measurement is…

Along with your Mighty Cord 30 Amp Twist Lock RV Power Inlet #A10-30INVP you can use their mating replacement female Twist Lock Connector #A10-30FDT. If you care to add a weather-resistant locking ring you can also use part #A10-30CV.

The Mighty Cord Replacement RV Power Inlet - Twist Lock - 30 Amp - White #A10-30INVP has a removable cover to protect the wire connections so I've measured the depth of the outlet with the cover on and off (pictured below).

The weld-on mounting bracket for the ARK #AR94FR Drop Down Corner RV Stabilizer Jacks measures 4-5/8 x 2-7/8 inches. The bracket has holes for the hardware that attaches the jack to the brackets. The holes are 2-7/8 inches apart on center.…

The Ark Drop Down Corner RV Stabilizer Jacks #AR34FR that you referenced installs by having the top of the bracket weld to the bottom of the RV frame.

The Ark Drop Down Corner RV Stabilizer Jacks - 2-1/2' Long Corner Steadies - Qty 2 #AR94FR you were looking at would do a great job of keeping your 2021 Rockwood Roo 21SSl steady, and offer a much larger foot than a standard scissor jack so…

While some manufacturers will say that a slide out jack isn't needed we've found that they do make a noticeable improvement to overall stability when parked which means a more solid feel when walking around in the RV and also less…

To replace your Dometic unit you'll first want to remove the cover for your air distribution box and look for the wire harness that hangs down from the rooftop unit and plugs into the controller. This wire harness will have either a 6-pin…

The RV Cabinet Door Struts #37270545 has installation instructions included with it that I've also attached a picture of below.

The MORryde Sliding Tray for RV Cargo Compartment - 72" x 20" x 6-5/8" - 500lbs - 2 Way #MR74FR has a 1.57" space between the mounting bracket and the floor of the slide.

End links cannot be added for adjustability when installing the Roadmaster Rear Anti-Sway Bar #RM-1139-193 on your 2020 Ford F-350. The reason is this replaces your factory sway bar and already utilizes the factory end links, and there isn't…

The Ultra-Fab Slide-Out Supports for Motor Homes, #UF19-960003 that you linked to are adjustable supports that mount between the ground and the frame of slide out to reduce slide-out sag. This adjustment ranges in height from 26" to…