Replacement Female 30 Amp Twist Lock Connector for Use with Twist Lock RV Power Inlet A10-30INVP

Question

Question:

Im looking at converting my RVs 30 amp power kit to a twist lock. I found Mighty Cord Replacement RV Power Inlet - 30 Amp Twist Lock - White... Code: A10-30INVP. Ill need the female end to convert the existing power cord. Do you have one? Or a kit that include both. Thanks.

asked by: Ivan R

1

Helpful Expert Reply:

Along with your Mighty Cord 30 Amp Twist Lock RV Power Inlet # A10-30INVP you can use their mating replacement female Twist Lock Connector # A10-30FDT. If you care to add a weather-resistant locking ring you can also use part # A10-30CV.

expert reply by: Adam R

1

Answer 1

The Mighty Cord Replacement RV Power Inlet - Twist Lock - 30 Amp - White #A10-30INVP has a removable cover to protect the wire connections so I've measured the depth of the outlet with the cover on and off (pictured below).

view full answer...

Answer 2

I went out to the warehouse and took some measurements of the top of the Ultra-Fab Slide-Out Supports, #UF19-960002. The inside width is 4-3/4 inches. The outside width is 5 inches. The height is 1-3/8 inches and the front to back measurement is…

view full answer...

Answer 3

The weld-on mounting bracket for the ARK #AR94FR Drop Down Corner RV Stabilizer Jacks measures 4-5/8 x 2-7/8 inches. The bracket has holes for the hardware that attaches the jack to the brackets. The holes are 2-7/8 inches apart on center.…

view full answer...

Answer 4

The Ark Drop Down Corner RV Stabilizer Jacks #AR34FR that you referenced installs by having the top of the bracket weld to the bottom of the RV frame.

view full answer...

Answer 5

The Ark Drop Down Corner RV Stabilizer Jacks - 2-1/2' Long Corner Steadies - Qty 2 #AR94FR you were looking at would do a great job of keeping your 2021 Rockwood Roo 21SSl steady, and offer a much larger foot than a standard scissor jack so…

view full answer...

Answer 6

Yes! To replace the mounting hardware for your White Dometic 310 Part-Timer RV Toilet #DOM57FR you need the 2-Bolt Mounting Kit #DOM43FR.

view full answer...

Answer 7

Once it's disassembled, once you access the rear of the socket you'll see that it's color coded as shown in the provided photo. The corresponding plug, like #A10-30FDT would wire in the same manner. The screws on each terminal are color…

view full answer...

Answer 8

A water heater like the Dometic RV Water Heater #DMC74FR that has a DSI system will not require additional wiring for just the DSI. A DSI and non DSI water heater will have 12 volt power that goes to operate the thermostats and DSI board for those…

view full answer...

Answer 9

If your electrical distribution system is not rated for 30 amps you should not be trying to plug into a 30 amp RV power pedestal at a camp site. From the attached images you are correct, you obviously have a 20 amp plug as it is clearly labeled for…

view full answer...

Answer 10

What you have there is an obsolete Bargman 35 amp power inlet. There ARE adapters out there, but they are VERY rare and therefore expensive. I'd recommend removing it and installing a modern 30 amp inlet like part #A10-30INVP along with a 30 amp…

view full answer...

Answer 11

We have the Progressive Dynamics Converter/Smart Charger at 35 Amp, #PD4135K. This is a replacement for WFCO WF-8735 that works with lithium-ion, flooded lead acid, AGM, and gel batteries. Please note the attached product review video and follow the…

view full answer...

Replacement Female 30 Amp Twist Lock Connector for Use with Twist Lock RV Power Inlet A10-30INVP

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching