TST TPMS RV Color Display ire Sensors Review Video

You can still use a Blue Ox base plate like the Blue Ox Base Plate Kit #BX1709 you're looking at. You're just going to need to also use an adapter like #RM-031 or #RM-031-5. The adapter you need will be dependent on the Roadmaster tow bar you…

We can help you out here, and first, thanks so much for the photo it was super helpful. And based on that I can tell you that your tandem axle trailer with #10 Torflex axles is absolutely compatible with the Dexter lift kit: - Torflex Lift Kit -…

The trailer tire size 215/75R14 that you have can fit on a 5.5 inch wide or 6 inch wide trailer wheel so either width will work fine. So the galvanized wheel part #AM20364 would fit and work well.

The Dexter Torflex Lift Kit #K71-707-02 referenced in your question is designed for the #10 Torflex axle with a 2,300 to 4,000 pound capacity. As you mentioned, the lift kit cannot be used with Torflex axles that use a 3 inch high profile bracket.…

The only difference between the TST TPMS #TST-507-RV-6-C and #TST-507-FT-6-C is the type of tire sensors that are included with each kit. Kit #TST-507-RV-6-C comes with 6 standard tire sensors, whereas kit #TST-507-FT-6-C comes with 6 flow through…

The load rating for the aluminum trailer wheel part #AM22329 that you referenced is 1,900 lbs per wheel. I am not sure what the weight of your trailer is so it's harder to determine if that would be enough. Most 14 inch trailer tire sizes have…

Normally the Mount-n-Lock SafetyStruts Universal RV Bumper Support Brackets #MO34VR install on outsides of trailer frame. I attached an install video for this for you to check out as well.

Torflex Lift Kit - Tandem Axle - 2-5/8" Lift Item #K71-707-02 doesn't require that you have your axles aligned after installation but it is good practice to do so. It is actually easier than you might think. Basically, measure from center of…

Since suspension components use lock nuts on the ends of the shackle bolts and the bolts need to be able to allow movement you actually don't want to torque down the bolts at all. You want to snug them up so that there's no lateral play but…

The hangers you currently have on your trailer are ones I have run into before. That being said, I spoke with MORryde and the #MR27ZR will still fit your trailer, but there is a modification that will need to be made. You’ll have to trim according to…

I contacted MORryde and this does happen from time to time as the weight of the trailer can spread out the axles due to downward pressure on the springs/suspension. Odds are the 35" wheel base #MR27ZR will be the correct one for you, but they…

You would be fine to use the Dexter Heavy-Duty Suspension Kit for Tandem-Axle Trailers #K71-449-00 that you referenced which has shackle straps that are 1-1/4 inch shorter than what you have now. The ride height of the trailer would lower slightly…