TruRyde Bearing Kit for #84 Spindle Installation Video

Hey Rob; thanks for the photos and it was actually the one with the hub number that did it. That's a BD 545 which is an AxleTek 3,500 lb hub and drum like the Trailer Hub and Drum Assembly #AKHD-545-35-K. The 35 on the axle sticker was a good…

The correct bearing kit you need for a Dexter 3,500 lb axle is the part #BK2-100 which comes with the bearings, races, and seal needed plus a tang washer and cotter pin.

For your Timbren Axle-Less Trailer Suspension #ASR2KHDS04 with the Timbren electric brakes and hubs you will need the Bearing Kit #BK2-100 for each hub. The bearing kit includes both bearings, races, a grease seal, cotter pin and tang washer. For…

The Timbren Axle-Less Trailer Suspension System part #ASR3500S06 will allow you to use parts from an existing 3,500 lb axle such as brakes, hubs, wheels etc. The spindle and brake mounting flange are no different than a traditional axle. In regards…

Yes, the Timken Bearing Kit #TMK52VR will fit your 3,500 lb axle as it fits an standard #84 spindle. The only time this kit won't fit with a 3,500 lb axle is if the trailer/axle is made before the 2000's since that's about the time that…

The inner diameter of the Stainless Steel Drive-In Grease Cap w/ Plug #DE69YR measures 1-7/8" (see attached).

The bronze bushings and wet bolts are a great option but they still do require maintenance especially under the conditions you referenced. There really isn't any new information in comparing it is basically the difference between maintenance…

Based on the information we have in our system you will need either the Lippert #LC66WD or Dexter #K23-478-479 brake kits for each of your axles depending on who manufactured your axle. These are 10" diameter by 2-1/4" wide brake…

The TruRyde Bearing Kit #BK2-100, has the correct inner bearing that you will need. You will need to match up the numbers stamped on the outer bearing, races, and seals, for the correct replacement parts. I have linked an FAQ on trailer bearings and…

If you remove the hub and wipe away the grease on the spindle you can check to see if it is damaged. Look for an scarring, gouges, discoloration, or scoring on the spindle. If the spindle is damaged then the bearings won't ride properly and can…

The part number on your Power Gear Slide-Out motor is actually 524908, for which the correct replacement is part #LC368200. I was able to confirm this with Lippert.

Yes, we can help you get this product. That part is the Replacement Gear Motor w/ MX2 Con. For Lippert Slide Out part #LC88UD, is the part you need for your 2009 Jayco Seneca Motorhome. . I have included a product description below.