Bearing Kit Recommendation for Dexter 3,500 lb Axle

Question

Question:

I am needing axle bearing kit for my Dexter 3500lb axle. Can you provide me with a part number?

asked by: Christopher F

0

Expert Reply:

The correct bearing kit you need for a Dexter 3,500 lb axle is the part # BK2-100 which comes with the bearings, races, and seal needed plus a tang washer and cotter pin.

expert reply by: Jameson C

0

Answer 1

The bearing kit part #BK2-100 is a kit designed specifically for 3,500 lb axles like what your trailer has. This will work well for your trailer and comes with all of the needed bearings, races and seal. I attached an install video for this kit for…

view full answer...

Answer 2

The part number on your Power Gear Slide-Out motor is actually 524908, for which the correct replacement is part #LC368200. I was able to confirm this with Lippert.

view full answer...

Answer 3

I reached out to Lippert and found that the correct replacement for your Power Gear Slide out motor 524065 is the Replacement Slide Gear Motor Assembly for Power Gear Slides #LC387738. Thank you for the pictures, it makes it way easier to find the…

view full answer...

Answer 4

Yes, we can help you get this product. That part is the Replacement Gear Motor w/ MX2 Con. For Lippert Slide Out part #LC88UD, is the part you need for your 2009 Jayco Seneca Motorhome. . I have included a product description below.

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 9

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 10

Yes, the Timken Bearing Kit #TMK52VR will fit your 3,500 lb axle as it fits an standard #84 spindle. The only time this kit won't fit with a 3,500 lb axle is if the trailer/axle is made before the 2000's since that's about the time that…

view full answer...

Answer 11

Hey Doug, thanks for reaching out! The MORryde ALLTREK 4000 #MR89DR dimensions can be a bit difficult to explain via text so I've attached an image giving you the dimensions you're asking about!

view full answer...

Bearing Kit Recommendation for Dexter 3,500 lb Axle

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching