How to Tell if a Trailer Spindle is Damaged or Needs to be Replaced
Question:
We just pulled our old popup Coleman into an rv park and noticed a squeak, the barrings are shot on driver side. How do I know if the axle is bad also? Repaor cost? Thank you for any advice!!
asked by: Stuck M
Expert Reply:
If you remove the hub and wipe away the grease on the spindle you can check to see if it is damaged. Look for an scarring, gouges, discoloration, or scoring on the spindle. If the spindle is damaged then the bearings won't ride properly and can fail again or it can cause other problems such as uneven or excessive tire wear and ride quality problems.
If the spindle is damaged then you can't really repair it and the whole axle should be replaced. I doubt that this is the case based on your description of the problem though. I have linked a video that might also help.
Product Page this Question was Asked From
Square #84 Spindle for 3,500-lb Trailer Axles - 1-1/2" Wide
- Trailer Spindles
- Standard Spindle
- 1-1/2 Inch Diameter
- Square
- For 3500 lb Axle
- TruRyde
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Shop: Easy Grease Trailer Idler Hub Assembly for 3.5K Axles - 5 on 4-1/2 - Galvanized
- Shop: Trailer Hub and Drum Assembly - 3,500-lb Axles - 10" Diameter - 5 on 4-1/2 - Pre-Greased
- Video: Remove, Inspect, and Reinstall Trailer Bearings, Race, and Seals Demonstration
- Shop: #84 E-Z Lube Spindle w/ Brake Flange for 3,500-lb Trailer Axle - 1-3/4" Diameter
- Video: etrailer Trailer Hubs and Drums - Hub - AKIHUB-545-35-G-EZ-K Review
- Q&A: Does a Spindle with Scarring and Complete Bearing Failure Need to be Replaced
- Shop: Dexter Trailer Hub and Drum Assembly for 2,200-lb E-Z Lube Axles - 7" Diameter - 4 on 4
- Q&A: Removing and Replacing Trailer Spindles
- Shop: Hub Bearing Kit for Lippert, Dexter, and AL-KO Axles - 3,500 lb with #84 Spindle
- Video: Review of Dexter Trailer Hubs and Drums - Hub with Integrated Drum - 8-173-16UC3-EZ
- Search Results: spindle
- Shop: Trailer Spindle Nut 1"
- Shop: Dexter Trailer Axle Beam with EZ-Lube Spindles - 89" Long - 3,500 lbs
- Search Results: axle
- Video: Timbren Axle-Less Trailer Suspension System Installation
- Search Results: dexter 3500
- Search Results: galvanized trailer axle
- Video: Kodiak E-Z Lube Disc Brakes Installation
- Video: Demco Cast Head Coupler with Jack Hole Review
- Shop: Brake Controller
- Video: Review of ABS Fasteners 1-3/4 Castle Nut Cotter Pin - 165649
- Shop: Trailer Hitch
- Q&A: Is It Okay to Pull Utility Trailer with Slight Spindle Damage?
- Article: How to Bleed Your Trailer Surge Brakes
- Q&A: Are Trailer Spindle # TRU47FR, Hub Assembly # 8-258BTUC1, and Tire/Wheel Combo # AM31985 Compatible
- Search Results: brake line kit torsion axle
- Search Results: spindle castle nut
- Q&A: Replacement Hub and Spindle for Dexter 69-46 Axle
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Search Results: crown nut