Rackem 5 Gallon Gas Can Rack for Enclosed Trailers Review Video

The Erickson ATV E-Track Tie-Down Kit #EM09160 is intended to secure your trailered 4-wheeled vehicle at the rear tires. The chocks are to be mounted in front of and behind the rear wheels as shown in the linked video and photo. If they were…

Since you will be using your E-Track system, part #E19148, for transporting more than one type of vehicle, you will want to try to find mounting locations that will work for all of them. The main consideration for deciding where to mount the…

It is certainly possible for any axle to wear out enough over time to need replacing. Since the suspension is built into a torsion axle if the suspension part was to wear out pretty much the only solution would be to replace the axle. If the…

You'd need a battery on your trailer to power the items you mentioned as a solar panel on a trailer would not have enough power for all of them at any given time. You'd want to use a solar panel like the #TLA7713 to charge…

Torque value ranges for lug nuts depend primarily on the diameter of the stud and the material the wheel is made of, 1/2-inch studs and a steel wheel in your case. In this instance a torque range of 90 - 120-ft/lbs is appropriate.

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

The wiring of the Go Power Solar Cable Entry Plate with Red and Black MC4 Cables #34273841REVA is tinned copper.

Thanks so much for the photos, and yes, you can add a solar panel and plug it in. What your photo shows is your solar controller is GP-PWM-10-SQ, and those plugs are MC4 branch connectors. That solar controller is a 190 watt, 10 amp controller, so…

You could use larger MC4 cable gauge wire from the Go Power Solar Cable Entry Plate #34273840 to your controller but it wouldn't benefit you very much unless you used larger gauge wire from the solar panel to the entry plate. Larger…

The Air Lift 1000 Heavy Duty Air Helper Springs #AL60818HD are only designed to work with your existing suspension system and provide additional stability for heavy loads on your 2012 Ram 1500. The springs are not designed to raise your factory…

There is a solution for you, but the lift kits you referred to such as #K71-725-02 will not work with welded on torsion axles. The best option is for you to simply remove your torsion axles and use the Timbren Axle-Less Trailer Suspension System…