Optronics Trailer Light Right Angle 2-Wire Pigtail Review Video

Hey Gus, it looks like the Optronics LED Clearance or Side Marker Light #MCL95AB is going to be the LED version of the #A91AB you're looking at. This light is a bit smaller though, measuring 3/8" shorter and 1/16" narrower, but it is…

I went and pulled a LED Trailer Stop/Turn/Tail Light #STL43RBX from our warehouse and measured the mounting holes and found them to be 4-1/4 inches apart. Of the lights we carry this will be the closest matching LED light to what you have.

They are single function lights, so they can be used as running lights or stop/turn but not both. So for your trailer to be legal, you will need to run two on each side, one for the running light (brown wire of your 4-way) and one for the turn/stop…

Standard 4-pole trailer wiring uses flat-style connectors, like part #W787268 which is a trailer-side connector and part #HM48044 which is the mating vehicle side connector. On these items and on the 16-gauge bonded 4-pole wire #16-4B-1 you…

I assume you are referring to butt connectors and if that is the case then these can very well be the cause of your issue as they can trap corrosion over time and cause problems. If you test for power on the wire going into the connector and then…

There would be a noticeable difference if you had both the Aero Pro light #STL37RB and the Glolight, #STL117RB right next to each other. You would notice that the Glolight seams to actually sort of glow rather than just light up. This is due to the…

The Optronics Grommet #A91GB that you referenced, which is designed to work with the Thinline LED #AL91RB that you were looking at, will install into a mounting hole on the trailer that is 2-7/8 inches across and 1-1/2 inches tall. If you do not have…

I pulled the 2 trailer lights you asked about so that I could take some measurements you wanted. I have attached a couple of photos with the dimensions noted on the photo. Part #BA65ARRB measures 5-7/16 inches long and 3-3/16 inches wide, and is used…

I can give you a list of parts below that will be needed to rewire a trailer which you can then use when combined with the labor rate of the shop to give you an estimate but it can be very hard to estimate the price of said job because the labor…

Normally the SAE number isn't a reliable way to pick out replacement lenses, but we know that the #A32RB is the correct replacement for a lens marked SAE-A-P2-DOT-02 like what you have. For an all new assembly you'd want the part #MC32RB.

I can help you find the correct parts for your EZ Loader trailer. Based on the photos you submitted, the #AL91RB will fit your style connector on your trailer. The amber light is #AL82AB, and the grommet you will need is #A91BOB. All these items come…

Yes, The Thinline LED Clearance and Side Marker Light #AL91AB has 2 male connector posts on it. This waterproof trailer light functions as both a clearance light and a side marker light when properly mounted. It is 2-1/2 inches long by 1-3/16 inches…