Optronics Light Guide LED Truck/Trailer Light Review and Installation Video

Based on my research the CM Trucks 1510304 uses the standard size oval lights on the flatbed. For stop, tail, turn lights you can use the #STL602RB. For reverse lights we have the #BUL602CB, or if you want a backup and tail function the #BUL602CRB.…

I have a solution for you that I can provide, but we aren't going to have a custom fit hitch to fit a vehicle like what you referenced. I spoke to my contacts at Curt and Reese and the only styles of hitches that can be made to fit a service body…

Your 4-pin/5-wire wiring harness is what is called a "wishbone" type which simply means that there are two separate running light wires, one brown and one pink. This allows a separate running light wire for each side of the trailer which…

Yes, you can use Kodiak Caliper-Mounting Guide Bolt Replacement Sleeve #K225SS for your Kodiak model 250 disc brake calipers. I confirmed with Kodiak that this is the correct part. All Kodiak disc brake caliper replacement parts are shown on the…

The 1992 Chevy C/K Series 1500 did not come with a port for a brake controller. Instead, you will need to hard wire the brake controller by first installing a 4-Way, #118315, and then installing a 7 and 4 Way Installation Kit, #ETBC7. If the Truck…

The E-Z Flex Heavy Duty Rubber Suspension System #K71-652-00 is designed for a tandem axle trailer. For a triple axle trailer you will need either #K71-657-00 with 7-3/4 inch long equalizers or #K71-656-00 with 5-5/8 inch equalizers. You would not…

I did some checking and it looks like on springs that are 25-1/4 inches in length measured from eye to eye you will want the distance from the first hanger to the second to be 29-1/2 inches, from the second hanger to the third you will need it to…

The Triple-Axle Trailer Hanger Kit #APTT3 that you referenced is designed to work on axles with capacities of 2,000 lbs to 7,000 lbs so it should work very well for you. I attached a picture that has a chart that shows exactly how you should space…

Since you said your tires were rubbing I would go with a hanger setup that is a little taller like the part #AP233-H248 which has 3-1/4 inch front/rear hangers and 3-5/8 inch center. Also, while the 60/40 rule for axle placement is a great starting…

Since LED lights prefer clear lenses for maximum brightness the part #STL211RCB that has the clear lens and red diodes would be brighter than the #STL211RB. If you check out the picture I attached you can see how the diodes of the #STL211RCB are…

I believe you are asking how to remove the lens of the Low Profile RV Combination Tail Light - Stop, Tail, Turn - 9 Diodes - Passenger Side part #RVSTL60. You will push in the two white tabs on the sides of the lights that have a cut out in the…

I can certainly help you with that. Since the Curt T-Connector Vehicle Wiring Harness, part #C55384 is a 4-way connector the four functions will be Yellow for the left turn and brake, Green is for right turn and brake, Brown is for running lights,…